Global B264040 User manual

Before you begin: Check components to verify all are included. Assembly requires two people and must be performed on a flat and
even surface. Do not overtighten hardware as damage can occur.
As of 10/2019
Page 1 of 3
CONTENTS
Ref. Qty. Description
1 1 Pre-Assembled
Top
2 3 Base
Supports
3 3
Left Seats
Ref. Qty. Description
4 3 Support
Arms
5 6 Anchor
Blocks
H1 1 Hardware
Pack*
72” Hex Table
Assembly Instructions
Assembly Instructions
Customer Service
US: 1-800-645-2986
Model #s: B264040, B264042, B2331053
Right Seats
*Contains: (6) 2 1/2" Hex Lag Screws
(30) 3 1/2" Hex Lag Screws
(36) Flat Washers
(9) 3" Deck Screws
Step 1
Secure anchor blocks to the bottom of each seat using 3 1/2" hex
lag screws and flat washers. The pre-drilled hole in the block will
face the seat side with three edges. Each seat will have one (1)
anchor block.
Step 2
Place the three (3) support arms on a flat surface. Fasten the
support arms together with 3" deck screws, two (2) per side.
Do not overtighten.

As of 10/2019
Page 2 of 3
Step 3
Align the pre-drilled holes in the seats and support arms, attach
using 3 1/2" hex lag screws and flat washers.
Installation Tip: Seats may fit tigthly side by side, tilt the seats up
slightly as you tighten lag screws to pull them down flush against
the support arms.
Step 4
Position the assembled seats and support arms assembly
approximately 10" to 15" above the floor. Tip: A five gallon
bucket under the center point of the assembly works well.
Step 5
The three (3) base support legs are rotated for shipping purposes.
A single deck screw is pre-installed, rotate the leg 90 degrees and
align the pre-drilled holes. Secure the leg with a supplied deck screw.
Repeat for all three (3) legs.
IMPORTANT NOTE FOR THE NEXT STEPS: DO NOT OVERTIGHTEN LAG
BOLTS. DO NOT LEAN ON TABLE TOP OR SEATS WHEN ASSEMBLING.
Step 6
Insert a base support in the open space of each of the three (3)
support arms, centering each leg on the pre-drilled countersunk
holes of the support arms. Attach the base support uprights to the
seat blocks with 2 1/2" hex lag screws and flat washers. Ensure the
seats are centered with the support arms.

As of 10/2019
Page 3 of 3
Step 7
With two people, carefully lift the table top and position the slots
in the top underside frame with the three (3) uprights. Slide the
top down onto the uprights. Ensure each upright is fully engaged
in the slot and the top is resting even and level.
B
A
Step 8
Attach each upright to the table top using a 3 1/2" hex lag
screw and flat washer, tighten fully. Hex head should be
within the countersunk hole. Attach all three (3) support arms
to the base uprights at the pre-drilled holes using a 3 1/2"
hex lag screw and flat washer.