Glyn XBeeSigfox Quick user guide

HARDWARE REFERENCE MANUAL
XBeeSigfox
A Wisol Sigfox module on an Xbee interface board
February 1, 2019
Revision 1.0

Revision Date Notes
1.0 22/06/2018 Initial hardware reference manual
Glyn Ltd. XBee Hardware Reference Manual Pg.1

Contents
1 Introduction 3
2 Mechanical Specifications 4
2.1 Dimensions ............................ 4
2.2 SocketTypes ........................... 4
2.2.1 10-Pin Right Angle Surface Mount Header . . . . . . . 4
2.2.2 U.FL Connector . . . . . . . . . . . . . . . . . . . . . . 4
3 Hardware Specifications 5
3.1 Pinout............................... 5
3.2 Antenna Connectors . . . . . . . . . . . . . . . . . . . . . . . 5
3.3 Hardware Commands . . . . . . . . . . . . . . . . . . . . . . . 6
3.4 PowerSupply ........................... 6
3.5 PowerConsumption ....................... 6
3.6 BlockDiagram .......................... 6
3.7 Recommended Module Summary . . . . . . . . . . . . . . . . 7
Glyn Ltd. XBee Hardware Reference Manual Pg.2

1 Introduction
The XBeeSigfox module has been designed to allow the user ease of use with
plug & play Sigfox module with the Digi R
XBeeTM interface. Options are
available for all Sigfox regional zones, R1, 2, 3, & 4.
By utilising the XBeeTM interface the XbeeSigfox allows the user the op-
tion to mount the module that best suits each particular application use case,
no matter where in the world it is going to be deployed.
In most cases your design needs to provide flexibility depending which
region the product is to be deployed. The XBeeTM form factor with XE910
module allows you to take the guesswork out of the design by providing a
single connector solution for interfacing the entire range of radio types avail-
able depending on your needs.
Full electrical and software (AT commands) compatibility is maintained
between each module type.
The Glyn XBee range also includes support for Cellular and LoRa mod-
ules.
Glyn Ltd. XBee Hardware Reference Manual Pg.3

2 Mechanical Specifications
2.1 Dimensions
2.2 Socket Types
2.2.1 10-Pin Right Angle Surface Mount Header
Manufacturer: Samtec Inc.
Part Number: TMM-110-01-T-S-SM
Pitch - Mating: 0.079”(2.00mm)
No. of Positions: 10
No. of Rows: 1
Mounting Type: Surface Mount
2.2.2 U.FL Connector
Manufacturer: Attend
Part Number: 321-33125
Glyn Ltd. XBee Hardware Reference Manual Pg.4

3 Hardware Specifications
3.1 Pinout
Pin Function Description
1 VCC Supply, supported range 3.3-4.2V
2 DOUT UART transmit
3 DIN UART receive
4 GND Ground
5 RESET nIN Reset Low
6 NC Not Connected
7 NC Not Connected
8 NC Not Connected
9 DTR UART data terminal ready
10 GND Ground
11 GND Ground
12 CTS UART clear to send
13 ON/nSLEEP 3.3V output, drives on-board LED via MOSFET
and connected to STAT LED
14 VREF Vref(Must be connected and >=3.3V)
15 GND Ground
16 RTS UART request to send
17 DIO3 3.3V GPIO3
18 DIO2 3.3V GPIO2
19 ADC1 3.3V ADC1
20 ON/OFF VCC must be driven to open drain/collector
3.2 Antenna Connectors
The XBeeSigfox module is equipped with a 50 Ohm RF connector from At-
tend, P/N: 321A-33125, for the wireless antenna connections. The connector
is located on the top side of the module.
Interface cables with various configurations are available from Glyn, to
suit your needs: Glynstore Interface Cable Range
Glyn Ltd. XBee Hardware Reference Manual Pg.5

3.3 Hardware Commands
Please see the relevant Wisol Sigfox Hardware user guide for more details.
The document can be found at Wisol website.
3.4 Power Supply
XbeeTM interface supports 3.3-4.2V.
Please see the relevant Wisol Sigfox Hardware user guide for recommended
power supply requirements for new designs. The document can be found at
Wisol website.
3.5 Power Consumption
Please see the relevant Wisol Sigfox Hardware user guide for recommended
power supply requirements for new designs. The document can be found at
Wisol website.
3.6 Block Diagram
Block Diagram of WSSFM10R4AT
Glyn Ltd. XBee Hardware Reference Manual Pg.6

3.7 Recommended Module Summary
Part Number Region Band Support
WSSFM10R4AT Europe & Middle East 868-869MHz
WSSFM10R2AT North America 902-905MHz
WSSFM10R3AT Japan 922-923MHz
WSSFM10R4AT South America, Australia, NZ, &
parts of Asia
920-922MHz
WSSFM11R2DAT Region 2 + Region 4 RCZ2 & RCZ4
Glyn Ltd. XBee Hardware Reference Manual Pg.7