Go Jo LTX-7 User manual

GOJO LTX-7
™
AND LTX-12
™
DISPENSER
INSTALLATION INSTRUCTIONS
These instructions apply to GOJO®, PURELL®, PROVON® and MICRELL®brand LTX-7 and LTX-12 dispensers.
Please read all instructions carefully before installing and using the dispenser.
Insert a at blade screwdriver into
the slots on the rell collar and
twist to separate the collar from
the rell. Unscrew the pump from
the bottle and discard.
1.
Bottle is recyclable.
2.
Open dispenser by by pushing
on one (or both) of the dual
side latches.
1.
Wait 24 hours before loading
rell.
5.
Remove cap from rell pump. You
will notice a small knob (E-key)
protruding from the white pump
collar – DO NOT REMOVE THIS
E-KEY as its removal will prevent
the rell from dispensing. Push
rell with E-key facing the back
plate, into pump house.
7.
When installing above a
countertop, be sure at least 6"
clearance is provided.
2.
6”
15.24 cm
Clean installation surface with
an alcohol pad. Allow surface to
dry for 60 seconds. Peel paper
off installation tape.
3.
Tape Installation (Steps 3, 4 and 5)
Press rmly on back plate for 10
seconds. For maximum adhesion,
do not load rell for 24 hours.
4.
Close dispenser. Battery indicator
light will initially alternate
blinking red and green. After a
few moments, indicator light will
consistently blink green when
the rell is properly loaded.
9.
Using back plate as a template,
press a pencil through the
installation tape to mark holes.
Mark and drill holes. Install with
#10 x 1” anchors and type A
#10 x 1” screws.
6.
Install 4 fresh D-cell alkaline
batteries according to diagram
shown on dispenser.
8.
Recycling
Fastener Installation
(Step 6)
Do not install in locations where dispenser may be exposed to wet environments, such as showers or areas where walls are
washed down. Installer can complete installation using tape, fastners, or both to secure dispensing system to the wall.

GOJO Industries, Inc.
One GOJO Plaza, Suite500
P.O. Box 991 • Akron,OH 44309-0991
Tel: [phone] • Toll-free: 1-800-321-9647
Fax: 1-800-FAX-GOJO©2019. GOJO Industries, Inc. All rights reserved. LTX 12 &7 Disp_Installation #27039
LOCK OR NOT™Technology
The dispenser is now locked.
3.
The dispenser is now unlocked.
3.
To lock the dispenser, remove key
from the key mount on the inside
of the dispenser.
Open the locked dispenser
by inserting the key into the key
hole on the top of dispenser.
1.
Open the dispenser by pushing
in one of the dual side latches
until it releases.
4.
The key to lock the dispenser is
located in the key mount on the
inside of the dispenser.
1.
To open a locked dispenser, insert
key into the key hole on
the top of dispenser.
4.
To return to unlocked, return the
key to the mount on the inside of
the dispenser.
2.
2.