Go Pet Club HGT-501 User manual

Hydraulic Grooming Table instruction (HGT-501)
Size: 35.43¡¡L*23.62¡¡W*(30.71¡¡-36.22¡¡)H
Parts:
A B C D E F G
H I J K L M N
A hydraulic pump
B underframe
C nut and washer(MM6)
D hydraulic pump foot lever
E hydraulic pump enclose
F screw(MM5)
G diagonal brace base
H screw and washer(MM10)
I diagonal brace
J screw, nut and washer(MM8)
K table board
L screw and washer(MM6)
M M4 M6 M8 spanner
N applying spanner 8MM 10MM, 12MM 14MM
Install clamps, arm and strap securely to side of table and turn screws
until tight.
Please see pictures for reference.
WARNING:
1, This table is for professional use ONLY
2, Never leave pets unattended while using grooming table.
3, For cleaning, please use a soft wash cloth and water.
Parts should look like the following picture after correct installation.

Assemble:
1,Insert (A) hydraulic pump to (B) under frame with (C) by (N), then
tighten the screws.
2, Insert (D) foot lever to the two holes of (A) pump, by (M).
3, Cover (A) pump with (E) enclose. Screw with (F) by (N) spanner.
4, Connect the (G) diagonal brace base with (A) pump, screw them with
(H) by (M). Remark:(H) extra washer is for spare, adjust it when need.
5, Connect (I) diagonal brace with (G) diagonal brace by (J).(Do not
tighten)
6, Connect (K) table board with (I) diagonal brace by (L), then tighten
the all parts.
7, Operation Instruction on Hydraulic Grooming Table;
Step on the foot lever repeatedly Step to bottom for landing.
to adjust the height.
Step to top for locking the table board.