Godox 固件说明
X1T-C Transmitter (For Canon) Firmware Instructions
1. Please update the firmware with Godox firmware update software G1. G1 can be
downloaded on the official website.
2. Firmware Version Checking: Switch the receiver off, then press the “MODE”button and hold
down. Turn the receiver on, and the firmware update version (e.g. Version 10 will read U-10) will
be displayed on the LCD panel.
2、Version Instructions:
1. To add the support of Canon EOS 200DII(Rebel
SL3/Kiss X10).
2. To add the support of Canon EOS RP camera.
3. To solve the compatible problem of Canon EOS R
camera.
1. To add the support of Canon EOS 1500D(2000D,
Rebel T7).
2. To add the support of Canon EOS 3000D(4000D).
3. To solve the problem that EOS R camera’s ISO will
be automatic.
1. To add the support of using TTL mode in EOS R
camera.
2. To add the support of EOS M50 camera.
3. To strengthen the wireless transmitting signal and
decrease the odds on not triggering in the
interference of external 2.4G wireless signals.
1. To add the support of using TTL mode in Canon
5Dsr camera.
1. To add the Fn-10 C.Fn custom setting so that the
customer can set RF ID value.
1. To add the support of Canon EOS 77D/800D/6D
Mark II cameras.
1. To solve the group values’dislocation problem in M
mode when the transmitter is controlled by the
camera.
2. The flash times in Multi mode are set by users
instead of being automatically restricted by the camera
shutter settings.
