Goelst Qurails G-Motion GM-1 Installation guide

Quick manual G-Motion type GM-1
Powering
i
3
6
5
Overview components
1
Please first read this manual carefully.
front side - Installing a G-Motion motor unit on
a Qurails 6200 curtain rail system.
back side - Setting end positions.
Identification motor type
2 basic controlling
buttons
connectors for
Tandem
(optional add-on)
connector for
Light sensor
connector for
- IR receiver
- switch / dry contact
- GM-Bus
cover : remove to access connector-area
and basic controlling buttons
- click -
LED
slide out
cover for
cabling:
gear,
connects to
curtain track
pulley
slide lock
First use: if NOT mounted on a 6200 rail system,
the motor unit runs in one direction only.
Set end
positions
GM-1xx-xxxx / xxxxx
“1”
(“4” or “6” : see other Quickmanual GM4 / GM6)
Made in the Netherlands100-240V ~1.5A 50-60Hz
CID: SW: HW: PD:
IP40
RoHS
4
( Split stack: )
2
1. 2.
3. 4.
!
(example)
Connector area
Adjust blocking positions
( If needed )
Mounting motor unit

+
=
=
=
NO
auto
20cm
auto
20cm
(c) 20220621 Qurails GM-QMEN-01
1
Setting end positions
7
Button instruction:
OK
>15 sec
< 15sec
For further settings: refer to main manual:
Strong appliance: danger of
- pinch point
- damage to the system: avoid hitting
end stops when setting end positions.
First use: if NOT mounted on a 6200 rail
system while setting end positions,
the motor unit will run in one direction only.
3
or
6
or
4
OK
7
2
stop!
5
= ok 5 6 7
2 3 4
stop!
press shortly
keep pressed
release
2?
?