Goelst Qurails G-Motion GM-4 Installation guide

3 5
Connector area
*
First use: if NOT mounted on a 6200 rail system, the
motor unit will run in one direction only.
NO auto calibration, see other Quickmanual GM1
“1”
calibration only with 4 or
5 core wiring AND ‘L’
connected, or with special
calibration cable
*
!
Adjust blocking positions
4
( Split stack: )
( If needed )
2 basic controlling
buttons
connectors for
Tandem
(optional add-on)
connector for
Light sensor
connector for
- IR receiver
- switch / dry contact
- GM-Bus
Powering
6
Mounting motor unit
1. 2.
3. 4.
“4”
Made in the Netherlands100-240V ~1.5A 50-60Hz
CID: SW: HW: PD:
IP40
RoHS
(example)
“6”
GM-4xx-xxxx / xxxxx
Quick manual G-Motion type GM-4 and GM-6
i
Overview components
1
Identification motor type
cover : remove to access connector-area
and basic controlling buttons
- click -
LED
slide out
cover for
cabling:
gear,
connects to
curtain track
pulley
slide lock
2
Please first read this manual carefully.
front side - Installing a G-Motion motor unit on
a Qurails 6200 curtain rail system.
back side - Setting end positions.

or
or
or
auto stop
+ 5cm
auto
System action :Start: auto stop
+ 1cm
Auto calibration cycle
7
auto
20cm
O.K.
adjust
5 sec
5 sec
5 sec
5 sec
O.K.
adjust
First use: if NOT mounted on a 6200 rail
system while setting end positions,
the motor unit will run in one direction only.
+
=
=
Button instruction:
press shortly
release
=
keep pressed
(c) 20220621 Qurails GM-QMEN-46
For further settings: refer to main manual: