Goldair GSCV150 User manual

Operating Instructions
ConvectorHeater
Model: GSCV150

General Care and Safety Guide
Thank you for choosing a Goldair Select Convector Heater. This Goldair
Select Heater has been designed and manufactured to high standards of
engineering and with proper use and care, as described in this leaflet, will
give you years of useful service. Please read these instructions carefully.
1. Use only the voltage specified on the rating
label of the appliance.
2. Keep all objects at least 1 metre from the front,
sides and rear of the appliance. Do not place
appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this may
cause an electric shock, fire or damage to the
appliance. Do not sit on the appliance.
5. Do not operate this appliance with a damaged
cord, plug or after the appliance malfunctions or
has been dropped or damaged in any manner.
Return to a qualified electrical person for
examination, electrical service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended by
the manufacturer and may cause fire, electrical
shock or injury.
8. The common cause of overheating is deposits
of dust or fluff in the appliance. Ensure these
deposits are removed regularly by unplugging
the appliance and vacuum cleaning the air vents
and grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always remove
plug from the mains supply before cleaning.
10. Do not connect the appliance to mains supply
until completely assembled and adjusted.
11. Switch off and use handles provided when
moving.
12. Do not operate with cord set coiled up as a heat
build up is likely, which could be sufficient to
become a hazard.
13. Do not use an extension cord, powerboard, or
external timer with this unit.
14. Do not remove plug from power socket until the
appliance has been switched off.
15. Do not remove plug from power socket by
pulling cord; always grip plug.
16. Always unplug appliance when not in use.
17. Do not locate the heater directly below any
power socket during operation.
18. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage area
and is unrolled before use.
19. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge, unless they are
supervised or have been given instruction
concerning the use of the appliance by a person
responsible for their safety.
20. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not be
immersed in any liquids.
21. When the appliance has been unpacked, check
it for transport damage and ensure all parts
have been delivered. If parts are missing or the
appliance has been damaged, contact the
Goldair Select Customer Services Team.
22. If your appliance does not work, or is not
working properly, contact the place of purchase
or the Goldair Select Customer Services Team.
Repair work on the appliance by unqualified
persons can cause serious risk to the user.
23. There are no user serviceable parts installed in
the unit.
24. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire
hazards.
25. This unit is not supposed to be used in or
around locations where foodstuffs, works of art
or delicate articles of science, etc are stored.
26. Indoor use only.
27. Children should be supervised to ensure that
they do not play with the appliance.
28. Ensure heater is on a flat, stable, heat-resistant
surface.
29. It is important that you do not cover this heater.
TECHNICAL SPECIFICATION
Model No: GSCV150
Supply: 220-240VAC 50Hz
Wattage: 1800-2000W

Operating your Convector Heater
•SAFETY DEVICE
•This appliance has two protection devices: The first
device automatically disconnects & reconnects the
appliance at a pre-set temperature.
•The second device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse (it is non resettable).
IMPORTANT! NEVER COVER THIS HEATER!
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
Do not attempt to dismantle the heater. There are
no user serviceable parts. For service or repair,
contact an authorised electrical service technician.
CAUTION: The heater generates heat during use.
Proper precautions must be taken to prevent the risk
of burns, scalds, fires or other damage to persons
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically, since a
fire risk exists if the heater is covered or positioned
incorrectly.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
ASSEMBLY OF THE HEATER
Each foot supplied with this heater (supplied
separately in the carton) requires only 2 screws to
attach them securely to the heater. Holes are pre-
drilled in the base of the heater.
The screw pack to attach the feet to your heater
will be taped to either one of the feet for your
heater, or taped to the plug head.
TIP: Slightly angle the screws into the holes when
you insert them. As you tighten them up, they will
straighten and secure the feet.
The foot comes with 4 pre-drilled holes. It does
not matter which way round you mount them.
HEAT CONTROL SWITCH
The control switch positions are:
“750W” Low heat
“1250W” Medium heat
“2000W” High Heat (Press 750W & 1250W
switches together)
Check that the On/Off switch is set to Off position
before plugging the heater into the mains supply.
For greater economy, use the High Heat setting
initially and then switch to the Lower Heat
settings.
THERMOSTAT
Turn the thermostat knob clockwise until you
reach the maximum temperature on the
graduated scale. When the desired room
temperature is reached, slowly turn the knob anti-
clockwise until the heater turns off (you will hear a
click). The heater will now cycle on and off to
maintain the set temperature.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
Goldair Select –New Zealand
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]z
Goldair Select –Australia
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[e-mail]
SUPPORT AND TECHNICAL ADVICE

Thank you for purchasing this Goldair Select product. Your product is warranted against faults and manufacture when
used in normal domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to
three months.
Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault
during the warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out
by anyone other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in
relation to the goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).
Two Year Warranty
Goldair Two Year Warranty (IMPORTANT: Please complete and retain this warranty card)
Name
Address
Place Of Purchase Date of Purchase
Name Of Product Model Number
Attach a copy of the purchase receipt to this warranty card
Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product.
Goldair –New Zealand
CDB Goldair
PO Box 100-707
N.S.M.C
Auckland
Phone [phone]
Phone [phone]
www.goldair.co.nz
Goldair –Australia
CDB Goldair Australia Pty
PO Box 574
South Morang
Victoria, 3752
Phone [phone]
Phone 1300 GOLDAIR (1300 465 324)
www.goldair.com.au