10
03 Daily use
Clock
Backup batteries
The Backup Battery is used to keep the correct
time and alarm time in case of a power failure.
Switch off the Speaker Dock and remove the
plug from the wall socket.
To replace the Backup Battery, open the
Memory Battery Compartment on the rear of
the Speaker Dock.
Insert a button cell (type CR2032), ensuring
the correct polarity is observed.
Close the Memory Battery Compartment.
Setting the clock
Make sure the Speaker Dock is powered on
before setting the clock.
Press and hold the SLEEP/CLOCK button.
SET will be shown in the LCD Display next to
the clock time.
Press the UP or DOWN ARROW buttons to
change the minutes.
Rotate the VOLUME CONTROL to change
the hour.
Press the SLEEP/CLOCK button to confirm
the new clock time.
The Speaker Dock will automatically return to
the last mode used prior to the clock setting
being changed.
Setting the alarm
Make sure the Speaker Dock is powered on
before setting the alarm.
Press and hold the ALARM button. ALM
and the alarm time will be shown on the LCD
Display.
Press the UP or DOWN ARROW buttons to
change the minutes.
Rotate the VOLUME CONTROL to change
the hour.
Press the ALARM button to confirm the
alarm settings.
Once the alarm setting has been confirmed,
press the ALARM button, or wait for a few
seconds and the Speaker Dock will return to
the previous mode.
The Speaker Dock will automatically return to
the last mode used prior to the clock setting
being changed.
Press the ALARM button briefly to toggle the
alarm mode on or off.
DON’T FORGET! The alarm will wake you
to the sound of the last mode used, e.g.
radio or iPod. If the iPod is removed from the
dock, a buzzer will sound.
Always adjust the volume to a comfortable
waking level.
Snooze mode
When the alarm sounds, you can press any of
the buttons (except the POWER button) to
activate the snooze function.
‘OFF’ will show on the display and the alarm
will turn off.
After approximately 6 minutes the alarm will
sound again. You can activate the snooze
function again or press the POWER button to
cancel the snooze function.
DON’T FORGET! This will turn off the
Speaker Dock and you will need to press the
POWER button again to turn the Speaker
Dock back on.
Sleep mode
The Speaker Dock can be programmed to switch
off after a set time, in increments of 10 minutes,
up to 90 minutes.
Press the SLEEP button until the required
minutes are shown.
Resetting the Speaker Dock
The Speaker Dock can be reset to return to the
factory default settings.
Switch off the Speaker Dock and remove the
plug from the wall socket.
To reset the Speaker Dock, remove the
Backup Battery from the Memory Battery
Compartment as described in the previous
sections.
Replace the Backup Battery after
approximately 2 minutes. The Speaker Dock
will be returned to the factory default settings.
GSPK90IPXI_UserGuide.indd 10GSPK90IPXI_UserGuide.indd 10 28/07/2008 16:50:0528/07/2008 16:50:05
