Graco Bravo harness User manual

Rear-facing: Birth to 30 lbs. (13.6 kg)
• Infants from birth to 20 lbs. (9.1 kg) MUST
be rear-facing.
• Infants or toddlers 20 to 30 lbs.
(9.1 to 13.6 kg) may be rear-facing.
HEIGHT & WEIGHT LIMITS
A preterm infant or low birth weight infant may
be at special risk in a vehicle or aircraft.
According to the American Academy of
Pediatrics, these infants may suffer breathing
difficulties if improperly reclined in a car seat.
Century advises that you have your physician or
hospital staff evaluate your infant and
recommend the proper car seat or car bed
before you and your infant leave the hospital.
1
Preterm or Low Birth Weight
Infants
Forward-facing
Forward-facing: 20 to 40 lbs. (9.1 to 18.1 kg)
• Toddlers 20 to 30 lbs. (9.1 to 13.6 kg) who
are capable of sitting upright unassisted
may be forward-facing *. If unable to sit
unassisted, use rear-facing.
• Toddlers 30 to 40 lbs. (13.6 to 18.1 kg)
and up to 40 inches (101.6 cm) tall MUST
be forward-facing.
Outgrowing Car Seat
Rear-facing
40 lbs.
(18.1 kg)
Birth 30 lbs.
(13.6 kg)
20 lbs.
(9.1 kg)
To avoid injuries from whiplash, top of
child’s ears must be below top edge of
car seat.
WARNING
IMPORTANT: This car seat is certified for use
rear-facing with children up to 30 lbs. (13.6 kg).
However, some children approaching 30 lbs.
(13.6 kg) may be too tall to fit comfortably
rear-facing. When child can no longer
comfortably fit and knees remain bent, child
should use car seat forward-facing only if child
is over 20 lbs. (9.1 kg) and can sit upright
unassisted *.
*The American Academy of Pediatrics recommends
that children should be at least one year of age
before being positioned forward facing.

OPERATIONS and ADJUSTMENTS
2
Buckle:
5-Point Models
• To buckle: Insert both tongues into
buckle. Pull up on tongues to be sure
they are locked.
• To unbuckle: Press red button and pull
tongues out of buckle.
Recline:
Recline - Rear-facing only
Semi-upright - Forward-facing only
Upright - Forward-facing only
To adjust: Pull recline handle out and rotate
car seat to desired position, then release
handle (fig. b).
Level Adjuster (Rear-facing only):
4 Positions to adjust to vehicle seat angle:
To adjust: Squeeze handle and rotate car seat
to position ball in green zone, then release
handle (fig. c).
IMPORTANT: Level adjuster must be in
position 1 when used forward-facing with
car seat in semi-upright or upright positions.
Harness Straps (fig. a):
• To tighten: Pull lower belt tab.
• To loosen: Pull and hold upper belt tab
while pulling harness straps.
Harness Tie:
• To open: Press tab and pull apart.
• To close: Snap halves together. Make
sure harness tie is locked by pulling out
on each half.
1
2
3
4
5

3
(fig. a) (fig. b) (fig. c)
1
2
3
4
5
Upper
Lower
OPERATIONS and ADJUSTMENTS (continued)

4
Changing Harness Strap Slots:
Rear-facing - MUST use bottom or middle
harness slots which are at or below shoulders.
Forward-facing - MUST use top slots.
A Loosen harness straps:
Pull and hold upper belt tab.
Pull harness straps out.
B Remove both harness strap loops from
Splitter Plate on back of car seat.
C Change harness strap slots.
Make sure harness straps are threaded
through matching slot of seat pad and
car seat.
It may be necessary to remove seat pad
from top of car seat.
D Re-attach harness strap loops to Splitter
Plate:
5-Point Models (fig. d):
• For Infants or Small Toddlers:
Put Top right strap loop on Splitter
Plate first, then attach Top left strap
loop.
NOTE: Make sure ends of straps are
behind Splitter Plate.
• For Toddlers:
Put Bottom right strap loop on Splitter
Plate first, then attach Bottom left strap
loop.
6
OPERATIONS and ADJUSTMENTS (continued)

5
(fig. d)
Bottom
Loop
Splitter Plate
Top
Loop
OPERATIONS and ADJUSTMENTS (continued)