Grandstream Networks GSC3570 User manual

Grandstream Networks, Inc.
126 Brookline Ave, 3rd Floor
Boston, MA 02215. USA
Tel : [phone] - 9300
Fax: [phone] - 1987
www.grandstream.com
For Certication, Warranty and RMA information, please
visit www.grandstream.com
In all EU member states, operation of 5150
- 5350 MHz is restricted to indoor use only.
GSC3570
Quick Installation Guide
HD Intercom & Facility Control Station

Content
English................................................................................1

~1~ ~2~
PRECAUTIONS
• Do not attempt to open, disassemble, or modify the device.
• Do not expose this device to temperatures outside range of -10 °C to 50
°C in operation and -20 °C to 60 °C in storage.
• Do not expose the GSC3570 to environments outside of the following
humidity range: 10-90% RH (non-condensing).
• Do not power cycle your GSC3570 during system boot up or rmware
upgrade. You may corrupt rmware images and cause the unit to malfunc-
tion.
GSC3570
4x Self-tapping
Screw Anchors
2x Self-tapping
Screws
EN
The GSC3570 is not pre-congured to support or make
emergency calls to any type of hospital, law enforcement
agency, medical care unit (“Emergency Service(s)”) or any
other kind of Emergency Service. You must make additional
arrangements to access Emergency Services. It is your re-
sponsibility to purchase SIP-compliant Internet telephone
service, properly congure the GSC3570 to use that ser-
vice, and periodically test your conguration to conrm that
it works as you expect. It is also your responsibility to pur-
chase traditional wireless or landline telephone services to
access Emergency Services.
GRANDSTREAM DOES NOT PROVIDE CONNECTIONS
TO EMERGENCY SERVICES VIA THE GSC3570. NEI-
THER GRANDSTREAM NOR ITS OFFICES, EMPLOY-
EES OR AFFILIATES MAY BE HELD LIABLE FOR ANY
CLAIM, DAMAGE, OR LOSS, AND YOU HEREBY WAIVE
ANY AND ALL SUCH CLAIMS OR CAUSES OF ACTION
ARISING FROM OR RELATING TO YOUR INABILITY TO
USE THE GSC3570 TO CONTACT EMERGENCY SER-
VICES, AND YOUR FAILURE TO MAKE ADDITIONAL AR-
RANGEMENTS TO ACCESS EMERGENCY SERVICES IN
ACCORDANCE WITH THE IMMEDIATELY PRECEDING
PARAGRAPH.
The GNU GPL license terms are incorporated into the de-
vice rmware and can be accessed via the Web user inter-
face of the device at my_device_ip/gpl_license. It can also
be accessed here: http://www.grandstream.com/legal/open-
source-software
To obtain a CD with GPL source code information please
submit a written request to [email protected]
PACKAGE CONTENTS
4x Self-tapping
Screws
OVERVIEW
The GSC3570 is a powerful Intercom phone for door control and 2-way
intercom. It features a 7” 1024x600 touch screen LCD, integrated dual-
band 802.11ac Wi-Fi, 100M network port with PoE, full duplex 2-way HD
audio with advanced AEC, and innovative telephony functionalities. The
GSC3570 is fully interoperable with nearly all major SIP platforms on
the market and can be seamlessly integrated with Grandstream’s entire
range of UC product lines including SIP based door systems, security
cameras, IP PBXs, and video conferencing systems and services. This
Intercom phone is the perfect choice for users looking for an integrated
video control and two-way voice communication solution for their wall-
mount and desktop.
1x Quick Installation
Guide
1x Installation
Bracket
1 PH2.0-10P
Alarm cable

~3~ ~4~
PWB3.5 x 6 x 8mm
PA3.5 x 33mm
Device Installation:
GSC3570 SETUP
1. Locate the equipment holder on the de-
sired position. Drill four holes on the wall
referring to the positions of the ones on the
metal bracket. Then, x a Screw Anchor in
each hole.
2. Fix the metal bracket on the wall by Self-
tapping Screws.
3. Plug in the cables to the proper GSC3570
ports on the back.
4. Align the position slots on device’s back
with their correct placement on the Metal
Bracket, then x it by pushing Down.
5. Plug in the Self-tapping Screws at bottom
to attach the device to the metal bracket.
The GSC3570 can be mounted on the wall or on the desktop (desktop brack-
et is sold separately). Please refer to the following steps for Wall installation:
1
3
4
Home Button
LED
LAN/PoE
Micro SD
Micro USB
10-PIN
Connector
Speakers
Touch screen
On-Wall Mount:
In-Wall Mount:
2
5
1. Locate the box screw holes and align them
with the metal bracket holes. Then, x a
Self-tapping Screw on each hole.
Below is the supported Box dimensions:
• 80mm x 80mm
• 71mm x 115mm
• 115mm x 115mm
2. Plug in the cables to the proper GSC3570
ports on the back.
3. Align the position slots on device’s back
with their correct placement on the Metal
Bracket, then x it by pushing Down.
4. Plug in the Self-tapping Screws at bottom
to attach the device to the metal bracket.
PWB3.5 x 6 x 8mm
115mm
115mm
1
2
3
4
115mm
71mm
80mm
80mm
OR
OR
GSC3570 Ports:
J1
J2
J3
J4

~5~
GSC3570 CONFIGURATION
1. Make sure the device is idle.
2. Slide to the second home page and press "Setting". Browse the GSC3570
MENU for Status, Network information, Features and Basic/Advanced Set-
tings...
3. Press "Home" Button to go back to Idle screen.
1. Ensure your device is powered up and connected to the Internet.
2. Slide to the second home page and press "Setting"
3. Select “Network Status” to check the IP address.
4. Type the unit's IP address in your PC browser. (See gure below).
5. Enter admin’s username and password to access the conguration menu.
(The factory default username is “admin” while the default random password
can be found on the sticker at the back of the unit).
Congure the GSC3570 Using a Web Browser:
Congure the GSC3570 from the LCD MENU:
Jack
Port
Function Remark
Pin
Signal
Color
J1
1
COM1
Orange
Alarm OUT 1 Relay output, normal open or close, max 125VAC/0.5A or max
DC 30V/2A
2
NO1
Yellow
3
NC1
Green
4 IN+ White Alarm IN
(Active)
Alarm isolated input, for voltage signal detection, IN+ connect the
sensor's signal output, please connect the GND to Alarm device's
GND or Negative of power. Active voltage range 9-15V
5
GND
Black
Alarm GND
Voltage reference for IN+, Switch signal reference for AIN (1/2/3)
6
AIN1
Blue
Alarm IN
(Passive)
Alarm input, for button/door contacts switch signal detection.
Please connect the Switch/button to AIN (1/2/3) and GND
7
AIN2
Brown
8
AIN3
Gray
9
GND
Black
Power Supply
DC12V recommend, input voltage rang 9-15V Current at least 1A
@12V
10
+12V
Red
J2 Network Port
- POE supply
- LAN port
Dual 10/100 Mbps Network ports: One is POE port with class AF
mode. The other one is a LAN port
J3
Micro SD Port
Data storage
Support microSD/SDHC/SDXC, up to 256G
J4 Micro USB Port Data exchange
Data exchange port, Not recommended to use this port to power
supply. If needed, please use 5V/2A adapter.
Refer to online documents and FAQ for more detailed
information: http://www.grandstream.com/our-products

For certification information, please refer to User Manuals:
http://www.grandstream.com
Common part：
This equipment complies with radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.This equipment should be installed and operated with minimum
distance 20cm between the radiator& your body.
U.S. FCC Part 68 Regulatory Information
This equipment complies with Part 68 of the FCC rules. Located on the equipment is a label
that contains, among other information, the ACTA registration number and ringer equivalence
number (REN.) If requested, this information must be provided to the telephone company.
The REN is used to determine the quantity of devices which may be connected to the
telephone line. Excessive REN’s on the telephone line may result in the devices not ringing in
response to an incoming call. In most, but not all areas, the sum of the REN’s should not
exceed five (5.0). To be certain of the number of devices that may be connected to the line, as
determined by the total REN’s contact the telephone company to determine the maximum
REN for the calling area.
This equipment cannot be used on the telephone company-provided coin service. Connection
to Party Line Service is subject to State Tariffs.
If this equipment causes harm to the telephone network, the telephone company will notify you
in advance that temporary discontinuance of service may be required. If advance notice isn’t
practical, the telephone company will notify the customer as soon as possible. Also, you will
be advised of your right the file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of the equipment. If this happens, the telephone
company will provide advance notice in order for you to make the necessary modifications in
order to maintain uninterrupted service.
If the trouble is causing harm to the telephone network, the telephone company may request
you to remove the equipment from the network until the problem is resolved.
This equipment uses the following USOC jacks: RJ45C.
It is recommended that the customer install an AC surge arrester in the AC outlet to which this
device is connected. This is to avoid damaging the equipment caused by local lightening
strikes and other electrical surges.
Since this device has the HAC function, the earpiece is easy to absorb small, please take care
to avoid scratching.
If trouble is experienced with this equipment, please contact (Agent in the US):
Company Name: Grandstream Networks, Inc.
Address: 126 Brookline Ave, 3rd Floor Boston, MA 02215, USA
Tel: [phone]
Fax: [phone]

U.S. FCC Part 15 Regulatory Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.

Canada Regulatory Information
Radio equipment
Operation of 5150-5250 MHz is restricted to indoor use only.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
Terminal equipment
This product meets the applicable Innovation, Science and Economic Development Canada
technical specifications.
The Ringer Equivalence Number (REN) indicates the maximum number of devices allowed to
be connected to a telephone interface. The termination of an interface may consist of any
combination of devices subject only to the requirement that the sum of the RENs of all the
devices not exceed five.
Ce produit répond à la innovation, des sciences et de Développement économique Canada
spécifications techniques applicables.
Le nombre équivalent de sonneries (REN) indique le nombre maximal de terminaux qui
peuvent être raccordés à une interface téléphonique. La terminaison d'une interface peut
consister en une combinaison de dispositifs, à la seule condition que la somme des REN de
tous les dispositifs ne dépasse pas cinq.

EU Regulatory Information
Support Frequency Bands and Power:
WLAN/BT 2.4 GHz < 20 dBm;
WLAN 5.2 GHz < 23 dBm;
WLAN 5.3/ 5.6 GHz < 20 dBm;
The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as
follows:
Hereby, [Grandstream Networks, Inc.] declares that the radio equipment type [GSC3570] is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
www.grandstream.com