GRAPHICS ONE GO FUZE Instructions for use

Application Manual
FUZE HANDHELD SYSTEM

1.Use the proper Fuze Solution
2. Please keep children away from the applicator and solution liquid3. Do not mix Fuze Solution with other liquids4. Verify the amount of Fuze Solution required prior to applying to substrate5. Recommended to be used on 100% cotton white and light fabricsNOTICE
CONTENT
In the Box
System Introduction
Fuze Handheld User Operation
Transfer Settings
Q & A
0
08
08

Items Required
1 x Bottle Fuze Solution 0
Fuze Handheld System
1 x Fuze Handheld ApplicatorWhat You Need
1
256437
0
1.2.3.Fuze Applicator
Fuze Solution
T-Shirt7. Parchment Sheet
4.5.6.Small Paint RollerPolyester FabricAcrylic Plate

0 0
1. Open the handheldFuze spray bottle and
fill it with GO Fuze™
solution.
2. Pump spray bottle fora few seconds to
pressurize the bottle.
This will allow it to
continually spray.3. Set the Fuze spraybottle nozzle to mist.It is recommended to check this prior to spraying the t-shirt.4. Place the T-shirt on the
Acrylic Plate and spray Fuze ™
solution to the t-shirt area you wish to sublimate your image.
Use a piece of cardboard to
cover the areas that will not
have the solution.
Spray evenly using 1 ml per
10 sq inches
5. After the Fuze™solution is sprayed, usea small paint roller togently push thesolution into the fibers.6. Take the shirt to the heat press and lay down parchment paper on top. Place the Polyester Fabric on top of the Parchment Sheet then press. This will help spread the heat evenly.8. It is recommended
pre-heating the lower
platen for 30 seconds
at a temperature of
365°F before pressing.7. It is recommended pressing for 10 seconds with a temperature of 365°F.Using Polyester Fabric on top of Parchment Sheet will help prevent your garments from yellowing.

0
Transfer Material
SubliMate Dye
Sub Paper
385°F35 ~ 40 s
Cotton 100%
TimT e
Medium
Heavy
Base MaterialRemarks
50% Cotton - 50% Poly
Printer TemperatureimeHeat Press PressureRemarks
Piezzo and
Micro TFP
Print Head
GO XPress
1620 SA
Mirror design
before printing.
Place a layer of
fabric on top of
your transferred
image prior to
pressing.
Washing Instructions
Recommended wash settings:
•Cold wash
•Delicate/Low temperature drying or Hang Dry
Have additional questions or concerns?
Contact our support team.
[email protected]
[phone]
11. Your shirt is ready.Note: Fuze coating feel should wear off after 1st wash. Recommended wash settings: Turn shirt inside-
out and wash with cold water
and low temperature drying.*Repeat steps 2-9 as needed10. Remove the shirt
from the press and let
it cool down for one
minute, then remove
the dye sublimation
paper.9. Place the t-shirt on
the press, center your printed dye sub image on top of the shirt.Place the Polyester Fabric to spread the heat and press for 70 seconds at 365°F.