Great day RAPID RACK RTR 200 User manual

“RAPID RACK” Removable Transport Rack
MODEL: RTR 200
READ ALL INSTRUCTIONS BEFORE INSTALLING RAPID RACK.
Instructions for Installation and Use:
FIG. 1
FIG. 2
CONTENTS: SEE FIG. 1
4- RAPID RACK UPRIGHTS, 4-LOAD
STOPS, 2-SPLICES, 4-MOUNTING BASES,
4-3/8” TOGGLE BOLTS, 4-5/16” x 2”
BOLTS, 12-5/16” x 2-1/4” BOLTS, 8-FLAT
WASHERS, 16-5/16” LOCKNUTS.
1) THREAD TOGGLE BOLT THRU
APPROPRIATE HOLE ON MOUNTING
BASES TO ALIGN BASE WITH STAKE
POCKET ON TRUCK BED RAIL. REPLACE
BUTTERFLY NUT. SEE FIG. 2

Fig.3
Fig. 4
Fig. 5
2) ALIGN MOUNTING BASES OVER STAKE
POCKET HOLES AND PRESS BUTTERFLY
NUT INTO HOLE. TIGHTEN BOLTS
SECURELY. THIS WILL ENGAGE THE
BUTTERFLY NUTS TO GRAB POCKET
HOLES AND HOLD RAPID RACK
SECURELY IN PLACE. SEE FIG. 3
3) SLIDE SPLICE INTO ONE OF THE RAPID
RACK UPRIGHTS AND SECURE WITH
5/16”X 2” FLAT WASHERS AND LOCKNUT.
SLIDE ANOTHER UPRIGHT ONTO THE
OTHER END OF THE SPLICE. **NOTE**
ONLY ONE END OF SPLICE IS PRE-
DRILLED. THE OTHER END WILL BE
DRILLED ONCE RAPID RACK IS
MOUNTED IN PLACE WITH IT’S FINAL
WIDTH DETERMINED.**ATTACH LOAD
STOPS TO RAPID RACK USING 5/16” X 2 ¼”
BOLTS AND LOCKNUTS. SEE FIG. 4
4) SLIDE RAPID RACK UPRIGHT SECTIONS
INTO MOUNTING BASES AND ATTACH
WITH 5/16” X 2 ¼” BOLTS AND
LOCKNUTS. SEE FIG. 5

Fig. 6
: WEIGHT CAPACITY: 200 LBS. NEVER EXCEED WEIGHT CAPACITY.
: NEVER TRANSPORT ANY CARGO WITHOUT IT BEING PROPERLY SECURED.
: NEVER STAND ON RAPID RACK.
: NEVER SIT OR STAND ON RAPID RACK WHILE VEHICLE IS IN MOTION.
: RAPID RACK IS NOT INTENDED TO OFFER ANY ROLL OVER PROTECTION.
: NEVER PLACE FOOT OR HAND ON RAPID RACK WHILE JUMPING OR
CLIMBING FROM VEHICLE.
For more information about this or other products, contact us at:
Great Day, Inc.
604 Kimbrough Dr. * Tallulah, LA 71282 * [phone] * www.greatdayinc.com
5) ONCE RAPID RACK IS BOLTED IN PLACE
DRILL THRU THE OTHER END OF SPLICE
USING A 5/16” DRILL BIT. THEN SECURE WITH
A 5/16’ X 2 ¼” BOLT AND LOCKNUT. SEE FIG. 6