Great Northern Docks 9079DL User manual

Slide Carriage Bolts
through Track
4
Connect the ladder hoops to the
oblong holes with the ladder between
each ladder hoop.
Use two hex bolts and two nuts
from the ladder bolt kit bag.
Threaded ends of all bolts should point to the outside
of the ladder to avoid the path of swimmers.
Place a stainless washer on the bolts between the
ladder and the hoop to allow the ladder to swing up and
down without grinding.
you will be able to place the ladder hoop brackets
into the large groove located on the top edge of
the DuraLITE frame.
Slide two carriage bolts from the ladder bolt kit bag
through the end of the track located on the bottom
of the DuraLITE frame.
The head of the bolt needs to be inserted at a 45°
These two bolts are to secure the ladder hoops once
they are attached.
up position so you do not have to hold it
while trying to attach it.
Having it assembled will space the hoops the right
distance apart from each other.
3
21
Ladder hoop
bracket
Groove
Great Northern Docks
Assembly Instructions
for DuraLITE
20° Aluminum Ladder #9079DL
Place washers on each end of the bolts.
Tighten nuts and bolts before using the ladder
nylock jam

X
X
56
7
The ladder hoop brackets have a notched opening
that will accept the carriage bolts you placed in the
track on step 4.
Make sure your bolts are slid to the notched side of
the hoop bracket before snapping the hoops onto
the dock frame.
To Snap the hoop into place, you can pull back on
the top of the hoop while thumping on the lower
part of the hoop (marked X above) until you hear it
click into the track.
If you want to remove the ladder from the aluminum
dock frame, pry the lower tab downward with a screw
the top of the hoop forward over the dock.
slide the carriage bolts into the notched openings
on the lower tabs of the hoop brackets. Secure them
with a washer and nut from your ladder bolt kit bag.
it to the end of the ladders’oblong holes.
8
Retract the “Ladder Spring Pins” to get the
the pin in the hole to hold the spring while
swinging the ladder down. Release the pins
from moving while in the down position.