greenair Luce 1242 User manual

Cleaning/Maintenance
7
Operation
6 Troubleshooting 8
Operation 5How it Works 3 Operation 4
CAUTION: Keep away from children and pets. Do not useon wooden
or painted surfaces that can be damaged by essential oil. Keep the
unit upright at all times. Do not tilt unit at any time as water may spill and
damage furnishings and fabrics.
Using incorrect water, distilled or purified
Unit needs to be cleaned. Oils are
clinging to ceramic disc or sensor
Clean unit as advised in
instructions with clean water
& clean ceramic disc/sensor
with brush or swab.
Use Tap Water (without filter)
Water level is higher than max level line
.
Clean unit and add water
1/2 way to fill line and
additional water after getting
mist.
Water level indicator is dirtyBlinking Lights
Unit will not stop
running even
though empty
No misting and
unit is spraying
water
Water level indicator is dirty
Water is too cold Change to warmer water.
Make sure all 3 parts are
assembled on top of unit.
Unit is out of water Add additional water
Clean unit as advised. Pay
particular attention to swab
the sensor/disc inside the
bottom of unit.
Clean unit as advised. Pay
particular attention to swab
the sensor/disc inside the
bottom of unit.
Make sure the cover is
aligned properly.
Cleaning:
• Rinse with warm water and clean as follows:
i. Wipe with soft damp cloth to clean.
ii. Wipe with soft cloth and rubbing alcohol when
needed to break up excessive oil residue.
iii.Use a cotton swab and water or rubbing alcohol
to clean the ceramic disc inside the base.
*See diagram to the left.
• We recommend cleaning the unit every time you
change oils or every 2 uses.
• Do not use detergents or abrasive agents
to clean the diffuser unit.
Do not return this diffuser to the retailer.
Please contact the manufacturer's customer
service for assistance. 1-888-548-0040
1 4
5
2
To control mist:
1st press will turn on
continuous misting.
2nd press will turn on
alternating mode.
3rd press will power
the unit off.
To activate timer:
1st press will set 1-hour
timer (automatic shutoff
after 1 hour)
2nd press will set 2-hour
timer (automatic shutoff
after 2 hours)
3rd press will set 3-hour
timer (automatic shutoff
after 3 hours)
3
oil fill
line
water
Using a cup, fill with
regular tap water up
to the max fill line.
Do not fill above
max fill line.
Add up to 10 drops of
your essential oil.
Replace the vapor
insert and cover.
First, plug the power
to the unit then
connect to a wall
outlet.
Remove the cover
and vapor insert.
Use a cotton swab and
warm water to gently
clean the mist disc and
sensor located at the
inside bottom of the
base.
CAUTION:
•DO NOT FILL BASE UNDER RUNNING WATER.
•DO NOT USE PURIFIED OR DISTILLED WATER.
•DO NOT MOVE ONCE UNIT HAS BEEN FILLED
WITH WATER.
Mist Disc
& Sensor
To activate lights:
1st press will turn on warm
white lights.
2nd press will turn on
colored rotating lights.
3rd press to select
displayed color.
4th press will turn off
the lights.
This essential oil diffuser uses high frequen-
cy Ultrasonic technology that vibrates cool
water inside the unit into an ultra fine mist.
When essential oils are added, they are
immediately dispersed into the air, provid-
ing immediate healthful benefits while
helping to ionize the air. It can be used in a
bedroom, living room, office area or any-
where you want to create a relaxing,
healthful, environment.