Greenes RC164812PTRE User manual

Questions?Email [e-mail] or call 800-622-5510 Monday - Friday 8am-5pm EST
PREMIUM CEDAR RAISED GARDEN BED WITH TRELLIS
ASSEMBLY INSTRUCTIONS
MODEL #
RC164812PTRE
DIMENSIONS
16in. wide x 4ft. long
x 11in. high
PACKAGE CONTENTS + (4) Screws
1. BUILD THE TRELLIS WALL
Hold a 16in. Board on the ground so it's standing on edge with the
notched ends to the left and right. Slide a Trellis Post down over one
notched end of the Board. Next, slide another Trellis Post over the other
notched end. This forms the Trellis wall.
2. BUILD A SHORT WALL
Repeat Step One using two Tall Posts to complete a second wall.
3. BUILD A FRAME
Place the walls parallel to each other and connect them into a
rectangle with two 4ft. Boards. This forms the frame of a 4ft. x 4ft.
Garden Bed with Trellis on one side.
4. FINISH GARDEN BED WALLS
Add one more Board, one at a time, directly on top of each existing
Board in the frame. Push the Boards down evenly between the tops
of the Posts. If needed, tap snugly into place with a rubber mallet.
5. BUILD THE TRELLIS
Slide one Spacer into the top of each Trellis Post, then add one
Slat on top of the Spacers and push them down directly on top
of the existing wall.
Repeat Step Four using all the Spacers and Slats to complete the Trellis.
6. ATTACH DECORATIVE CAPS
When the Trellis is completed, attach each Decorative Cap to a Tall Post
and Trellis Post with a screwdriver and Screw. We recommend drilling a
pilot hole in each Cap first.
12in. x 2.5in.
x 2.5in.
Tall Posts
x2
4ft. x 5.5in.
Boards
3.5in. x 3.5in.
Decorative Caps
x2 x4 x4 x10 x20 x4
46.5in. x 2.5in.
x 2.5in.
Trellis Posts
16in. x 5.5in.
Boards
16in. x 1.25in.
Trellis Slats
Trellis
Spacers
NEED HELP?
Contact customer service
instead of returing item to store.
800-622-5510 M–F 8–5
[e-mail]
INSTALL ATION SUPPORT
youtube.com/greenesfence

NEED HELP?
Contact customer service
instead of returing item to store.
800-622-5510 M–F 8–5
[e-mail]
INSTALL ATION SUPPORT
youtube.com/greenesfence
7. ATTACH DECORATIVE CAPS
When the Trellis is completed, attach each Decorative Cap to a Corner
Post or Trellis Post with a screwdriver and Screw. We recommend drilling
a pilot hole in each Cap first.