Greenes RCP2T10S31B User manual

PACKAGE CONTENTS + (8) Screws
. BUILD A FRAME.
Place the walls parallel to each other and connect them
into a square with two more Boards. This forms the Frame
of the Garden Bed.
. CONNECT THE WALL FROM STEP 3 TO ONE SIDE
OF THE COMPLETED FRAME
Extend two Boards parallel to each other from the Short Posts on one
side of the completed Frame, and connect the wall from Step 3 over
the other ends to complete a second frame.
. BUILD A WALL WITH TALL POSTS.
Questions?Email [e-mail] or call 800-622-5510 Monday - Friday 8am-5pm EST
ORIGINAL PINE RAISED GARDEN BED | ASSEMBLY INSTRUCTIONS
x8
Decorative
Caps
x31x2
. BUILD A WALL WITH SHORT POSTS.
Hold a Board on the ground so it's standing on edge with the notched
ends to the left and right. Slide a Short Post down over one notched
end of the Board. Next, slide another Short Post over the other
notched end. This forms a wall.
Repeat this step to complete a second wall.
*See back for next steps
x10
4ft. x 3.5 in.
Boards
8in. x 2.5in. x 2.5in.
Short Posts
11in. x 2.5in. x 2.5in.
Tall Posts
MODEL #
RCP2T10S31B
DIMENSIONS
4ft. wide x 12ft. long
x 7in.- 10.5 in.-14in. high
Short Posts
Tall Posts
2 Stacked
Short Posts
. COMPLETE THE THIRD FRAME.
Connect two Boards to one side of the second Frame and add two
more Short Posts and a Board to finish the final Frame.
. ADD A SECOND BOARD TO ALL WALLS.
Add Boards, one at a time, directly on top of each existing Board
in the frame. Push the Boards down evenly between the tops of all
Posts. If needed, tap snugly into place with a rubber mallet.

. ATTACH FOUR MORE SHORT POSTS ON TOP OF THE FIRST FOUR
TO CREATE THE TALLEST FRAME.
The Posts are taller than the Boards so Beds can be stacked.
. ADD A THIRD BOARD TO THE WALLS OF THE CENTER AND OUTSIDE FRAME
MADE WITH SHORT POSTS.
NEED HELP?
Contact customer service
instead of returing item to store.
800-622-5510 M–F 8–5
[e-mail]
INSTALL ATION SUPPORT
youtube.com/greenesfence
. ADD A FOURTH BOARD TO EACH WALL OF THE TALLEST FRAME
& ATTACH DECORATIVE CAPS.
When the Garden Bed is completed, attach each Decorative Cap
to a Corner Post with a screwdriver and Screw. We recommend
drilling a pilot hole in each Cap first.
Short Posts
Tall Posts
2 Stacked
Short Posts