Grizzly H8246 User manual


WARNING: NO PORTION OF THIS INSTRUCTION SHEET MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

Figure 1.
For questions or help with this product contact Tech Support at [phone] or [e-mail]
MODEL H8246
WIDE SINGLE MINI
ON/OFF SWITCH
INSTRUCTIONS
Introduction



Specifications
 

To reduce risk of serious burns, electrocu-
tion or death when installing this switch:
• Only use this switch to replace an exist-
ing component switch that has the same
physical configuration and equivalent
electrical specifications/ratings.
• Installationmustonlybeperformedbyan
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
• Turn off and completely disconnect all
power sources to the component before
installing the switch.
• Onlyinstallthisswitchonthe"hot"wires.
Do not install it on the neutral or ground
wires. Otherwise, the component could
still be receiving live current even when
the switch is turned OFF.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or rated
for these environments.
• Make sure there is a verified compo-
nent ground on the circuit this switch is
installed.

 
Hot
In
Hot
Out
ON
(|)
OFF
(O)
KEDU HY39
Component
Verified
Ground*
Power Source
Rear View
of Switch
Figure 2.
Installation

  Figure 2     

This switch is intended to be connected to
stranded wire with insulated quick-discon-
nect crimp-type female wire terminals hav-
ing a 1⁄4"tab.
Allcrimpsmustbe"pull-checked"toensure
that wires are securely crimped and will
not fall out with moderate tension or when
exposed to normal operation vibration.

       


