Gronomics EGB 18-48 User manual

www.gronomics.com East Bethel, MN USA 763-753-7374
Continued
ITEM QTY.
Parts List
1 4
2 2
3 4
4 2
5 2
PART #
3200E
4502T
1450T
4501T
1451T
Corner Post, 4” x 4” x 32 w/2 dovetailed sides 12-3/4
Side Rail w/Cleat, 45” x 5-1/4” x 7/8”
Side Rail, 14-1/2” x 5-1/4” x 7/8”
Side Rail Narrow Center, 45” x 2-1/2” x 7/8”
Side Rail Narrow Center, 14-1/2” x 2-1/2” x 7/8”
6 2 4500T, L4500T Side Rail (one w/Logo), 45” x 5-1/2” x 7/8”
7 2 Corner Notched Bottom Board, 15” x 5-3/8” x 1”
8 6
1538N
1538
9 4 4545
10 1 FL3652
Bottom Board, 15-3/8” x 5-1/2” x 1”
Post Cap, 4-5/8” x 4-5/8” x 1-1/2”
Fabric Liner 36” x 52”
1
Parts Identification
Stack matching pieces in piles. Using the parts list,
locate and count the individual pieces and verify that
you have received the correct number of pieces.
If any pieces are missing or replacement parts
are required, contact Gronomics at
1-855-299-6727.
NOTE: Ground preparation is optional, however
we reconnend leveling area under frame of
product, or place product directly on a flat level
surface before filling with soil.
Elevated Garden Bed (18” x 48”)
Assembly Instruction
Item #: EGB 18-48
Item #: EGB 18-48S
5
6
8
9
3
4
7
1
10
10
Packaged & Inspected by: Date:
2
Side Rail Assembly
2
Stand two 4” x 4” x 32” corner posts (Item 1) upright with slots facing you
and slots facing each corner post.
Locate a 45” x 5 1/4 “ side rail w/cleat (Item 2). With the cleat located at the
bottom and facing you, install side rail w/cleat into the slots and slide down
to the bottom of the slots.
Repeat procedure for the two remaining corner posts and 45” x 5-1/4 “ side
rail w/cleat.
Cleat
1 1
2
Product Care and Maintenance
DESCRIPTION Western Red Cedar will turn a
weathered grey if left unfinished.
Although no finish is required for
cedar when used outdoors, a natural
oil finish applied regularly will help
maintain the beauty and minimize
cracking and drying. It is
recommended to use Gronomics
Garden Bed Oil (Item # GBO-1Q), a
non-toxic, food safe finish that is very
easy to apply. Apply Oil when air and
wind temperatures are between
50-90degrees. Avoid applying in
direct sunlight.

www.gronomics.com East Bethel, MN USA 763-753-7374
Install two 14” x 5-1/4” side rails (Item 3) (with the groove down) into the
slots and slide down to the bottom of the slots.
6
Bottom Board and Fabric Installation
Place one 15” x 5-1/2” corner notched bottom board (Item 7) on each
end of the garden bed.
Place six 15” x 5-1/2” bottom boards (Item 8) into the garden bed. (Gap
boards evenly to allow for water drainage).
Place fabric liner into the garden bed.
Soil Depth: approximately 12-1/2”
Soil Capacity: 4.1 Cubic Feet
3
End Rail Assembly
3
3
7
8
4
Narrow Center Side Rail Assembly
Install two 45” x 2-1/2” side rails (Item 4) into the slots on each side of
the garden bed and slide down.
Install two 14” x 2-1/2” side rails (Item 5) into the slots on each end of
the garden bed and slide down.
NOTE: Make sure the boards tongue and grooves fully seat together.
45
5
5
Final Side Rail Assembly
Install two 45” x 5-1/4” side rails (Item 6) (one with Logo) into the slots
on each side of the garden bed and slide down.
Install two 14” x 5-1/4” side rails (Item 3) into the slots on each end of
the garden bed and slide down.
NOTE: Make sure the boards tongue and grooves fully seat together.
Logo
63
3
7
Post Cap Assembly
Remove the rubber cap from the corner posts studs.
Align the hole of the 4” x 4” post cap (Item 9) with stud and tighten until
the cap makes contact with the post.
NOTE: Do not overtighten.
Repeat procedure on all posts.
Rubber Cap
Stud
9