Gronomics RUSTIC Series User manual

AssemblyInstructionSheet 30-Sep-11
GRONOMICS® RUSTIC SERIES
“TOOL FREE ASSEMBLY”
24” x 48” x 30” RUSTIC ELEVATED GARDEN BED
Parts Check List and Assembly Instructions
STEP I
A) Unpack all of the parts and organize them in ‘like’ stacks. Please read the instructions
in its entirety before beginning assembly.
You should have: Model #REGB24-48
QUANTITY
PART DESCRIPTION
PART #
4
4” x 4” x 30” Corner Post w/11” Dovetail Depth
R7012
4
4” x 4” x 1½” Post Cap
R3100
Parts for the Sides
4
21” x 5½” x 1” Side Rails
R7007
2
45” x 5½” x 1” Side Rails with Cleat
R7011
2
45” x 5½” x 1” Side Rail (One w/Logo)
R4501, R4501L
Parts for the Bottom
2
22”x 5½” x 1” Corner Notched Bottom Board
R1201
6
22”x 5½” x 1” Bottom Board
R1200
1
18” x 48” Fabric Liner
2003
Packaged & Inspected by:________________________________ Date:________________________
NOTE: If you need assistance with parts or have assembly questions, please contact Customer Service
either via email or at [e-mail] or phone at 763-753-7374.

AssemblyInstructionSheet 30-Sep-11
GRONOMICS® RUSTIC SERIES
“TOOL FREE ASSEMBLY”
STEP II
A) Start by standing up two of the four 4” x 4” x 30” posts.
B) Slide a 45”x 5½” x 1” side rail with cleat on bottom
between the posts. (see figure 1)
C) Repeat the same process with the other two 4” x 4” x 30”
posts and 45”x 5½” x 1” side rail with cleat.
Soil depth options: The directions as printed will provide an
elevated bed with a soil depth of approximately 10”. If you
want a soil depth of approximately 6”, just reverse the position
of the lower side rail with the cleat on top.
STEP III
A) Slide both of the 21” x 5½” x 1” side rails between the
posts on both sides. Slide the two 45” x 5½” x1” in next,
do the same with the two 21” x 5½” x 1” side rails.
Note: Placement of 45” x 5½” x 1” side rail w/logo.
(see figure 3)
STEP IV
A) Place the two 22” x 5½” x 1” corner notched bottom
boards on the end cleats. Make sure the corner cut-out
notches are in the corners.
B) Place the remaining 22” x 5½” x 1” bottom boards on the
cleats. (Gap between boards to allow water drainage.)
STEP V
A) Carefully remove the screw covers that are protecting the
cap screws. Place the cap on the center of the screw
utilizing the pre-drilled hole in bottom of the cap. –Do not
over tighten. (see figure 3)
B) Place the fabric liner on the bottom.
1-Year Warranty: All Gronomics®products are warranted against all manufacturing defects of material or craftsmanship for a period of ONE full
year from date of purchase. Warranty does not cover cracking, damage caused by negligence, alterations or abuse in any way.
(Figure2)
(Figure 3)
(Figure1)