Gronomics MRGW 34-48 User manual

www.gronomics.com East Bethel, MN USA 763-753-7374
Continued
Modular Rustic Garden Wedge
(34”W x 48”L x 32”H - 18D) Assembly Instruction
Parts List
ITEM QTY. PART # DESCRIPTION
1 4 CP41 Corner Post, 3-1/4” x 3-1/4” x 41-1/4”
2 8 R4501 Front & Back Side Rails, 45” x 5-5/8 x 13/16”
3 2 ES2613L End Side Rails, 26-3/8” x 5-1/2” x 13/16”
4 2 ES2013 End Side Rails, 20-1/4” x 5-1/2” x 13/16”
5 2 ES1313 End Side Rails, 13.7/8” x 4-3/8” x 13/16”
6 2 ES0713 End Side Rails, 7-3/4” x 5-1/2” x 13/16”
7 2 SH43 Shelves, 43-3/4” x 5-1/2” x 1-3/8”
8 1 BCR43 Bottom Center Rail, 43-3/8” x 2-1/2” x 13/16”
9 4 R3100 Post Cap, 4-5/8” x 4-5/8” x 1-1/2”
10 1 FL3652 Fabric Liner, 36” x 52”
1
Parts Identification
Stack matching pieces in piles. Using the parts list, locate and count
the individual pieces and verify that you have received the correct
number of pieces.
If any pieces are missing or replacement parts are required, contact
Gronomics at 1-855-299-6727.
NOTE: It is recommended to place a protective layer between
the ground and the pieces during assembly. This will help prevent
damage to the pieces.
MRGW 34-48
Place two 3-1/4” x 3-1/4” x 41-1/4” corner posts (Item 1)
together as shown.
Repeat procedure for the two remaining corner posts.
Post Assembly
2
Packaged & Inspected by: Date:
1
12
345
6
7
9
10
10
8

www.gronomics.com East Bethel, MN USA 763-753-7374
Side Rail Assembly
3
Install the eight 45” x 5-5/8” side rails (Item 2) into the upper
part of the slots between the corner posts and slide down.
2
2
Install the 43-3/8” x 2-1/2” bottom center rail (Item 8) with the
tapered edges of the rail facing down.
Install the fabric liner into the Garden Wedge.
Soil Capacity: 6.5 Cubic Feet
Bottom Center Rail Assembly
5
8
End Side Rail Assembly Continued
4
Install the four end side rails (Item 6, 5, 4 & 3) into the
upper part of the slots between the two corner posts and
slide down.
Repeat procedure on the opposite end with the four
remaining end side rails.
5
4
3
6
Remove the rubber cap from the post studs.
Align the hole of the 4” x 4” post cap (Item 9) with stud and
tighten until the post cap makes contact with the post. Do
not overtighten.
Post Cap Assembly
7
9
Stud
Install the two 43-3/4” x 5-1/2” shelves (Item 7) onto the side
rails on both sides of the Garden Wedge.
Shelve Assembly
6
7