GROW Illumination Pro Series User manual

OPERATION
MANUAL
PRO
Series

OPERATION MANUAL
INTRODUCTION PRO Series
THANK YOU
02
The F660, F660-B, and F660-G “Blaze” is part of our Pro Series family of Grow Lights. This high performance
LED grow light was designed for commercial applications and is DLC, CE, and ETL listed. This fully dimmable
light has 2 built in RJ ports for use with our Pro Touch Controller, along with a foldable design that is easy to
transport and move around. With its high PPF and uniform light output, this is a perfect light for all growers.
Thank you for choosing Grow Illumination’s “PRO Series” LED Grow Lights. This manual pertains to Pro Series
“Blaze” F660, F660-B, and F660-G. Please READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS
PRODUCT. This manual provides important information on proper operation. Every effort has been made to
ensure the accuracy of this manual. These instructions are not meant to cover every possible condition and
situation that may occur. We reserve the right to change this product at any time without prior notice.
FULL SPECTRUM
All of our LED Grow Lights are FULL SPECTRUM.
Meaning they can be used during the VEGETATIVE
or FLOWERING stages.

OPERATION MANUAL
PRODUCT SPECIFICATION
Measured Power 660 Watts +/- 2%
Efcacy 2.7 umol/j - 2.6 umol/j
CRI 90+
Amp Draw 5.4A @ 120v
2.9A @ 240v
2.6A @ 277v
Input Voltage Range Auto sensing 120-277 VAC 50/60 Hz
PPF 1850 - 1650 umol/s
THD <10%
Power Factor >0.95
Surge Protection 6 kV
Dimmable Yes
Dimmable Range Selectable 100%, 75%, 50%, 25%
RJ Dimming Ports Yes (2x)
Number of LED Bars 6
Lifespan 50,000+ hours
Thermal Cooling Passive
Flowering Coverage 4’ x 4’
Vegetative Coverage 5’ x 5’
Mounting Height 6” + Above Canopy
Certications ETL and DLC Listed
Warranty 5 Years
Damp Rated Yes UL1598 (IP65)
Dimensions 46” x 45” x 2.5”
03

OPERATION MANUAL
INTENDED USE:
Safety Warnings
Grow Illumination’s PRO Series “Blaze” F660 are high-performance LED lights, designed for commercial
and home horticulture. It’s suitable for indoor use and damp environments. This light should only be hung
from its integrated hanger points on top of the frame of the light.
* Grow light warranty found on
the website
The PRO Series “Blaze” F660 is passively cooled. Do not try to open or disassemble the fixture, it contains
no service parts inside. Doing so may cause harm to the fixture and void warranty.
• Always adhere to the local rules and regulations
when installing or using the fixture.
• Wearing protective gloves and glasses is
recommended during installation.
• Always disconnect from the mains before
performing any maintenance to the fixture.
• The fixture will get hot during operation. Do not
touch while the light is on. Keep this product
away from children.
• Always allow at least 10 minutes for the fixture to
cool down before handling.
• Do not touch the LED diodes.
• Keep the power cord away from hot surface.
• Do not plug this system into a supply voltage
other than what is instructed on the fixture.
• Do not use the fixture when the power cord is
damaged.
• Do not use the fixture when the unit has been
dropped, or its enclosure or bars are damaged.
• Risk of electrical shock. To reduce the
possibility of serious injury, always take
the proper precautions and unplug the
fixture before moving or cleaning.
• Light bars and power supply are splash-
proof but not waterproof. In the event that
the light bar becomes submersed, first
disengage the circuit breaker, then unplug
the fixture before proceeding to remove
from water.
• To reduce the risk of overheating or fire,
never place operating fixtures face down on
a flush surface. Always allow for adequate
ventilation of fixtures and power supplies.
• To prevent eye damage, avoid looking
directly at the unshielded LEDs.
04

OPERATION MANUAL
05
SET UP:
• Unbox light and place facing down on flat area or table.
• Attach your ratchet hangers on each of the four tabs
located on the frame. You may use other means of
suspension cables that can be mounted to the same tabs.
• Place light into area that you will be using and adjust
your height needed for your area (we suggest a 6” to 8”
above your canopy). Prior to plugging in the light, make
sure your switch or power is off.
NOTE: Do not touch or handle the LEDs on the light as you
may damage them, always hold the light by the outside frame.

OPERATION MANUAL
06
• If your using the Pro Touch Controller, plug the cables in at this time. If your not, skip to next step.
• Power on your light and adjust dimming by either the controller or manual knob.

OPERATION
MANUAL
PRO
Series
6800 Gulfport Blvd S.
Suite 201-179
St Petersburg, FL 33707
(727)-300-9615
[e-mail] rev 1121
www.growillumination.com