Grundig MT 6742 User manual

PROFESSIONAL
MULTI
HAIR TRIMMER
MT 6742
DE
FR
EN
HR
TR
PL
ES

2
________________________________________________________
1 2 3 4
7
5 6
8 9

3
_________________________________________________________
A
B
E
B
C
D
F

4
_________________________________________________________
DEUTSCH 05-16
FRANÇAIS 50-60
TÜRKÇE 28-38
POLSKI 72-82
ENGLISH 17-27
HRVATSKI 61-71
ESPAÑOL 39-49

ENGLISH 17
SAFETY ___________________________________
Please note the following instructions
when using the appliance.
7 The appliance is designed for
domestic use only.
7 Observe these instructions in order
to prevent damage to the appli-
ance or danger arising from
improper use. Keep them in a safe
place.
7 Never use the appliance in the bath,
shower or over a wash basin filled
with water; nor should it be operated
with wet hands.
7 Do not immerse the appliance in
water or let it come into contact
with water, even during cleaning.
7 Do not drop the appliance.
7 If not already present, for addi--
tional protection it is recommend to
install a residual-current-operated
protective device (RCD) with a
rated residual operating current not
exceeding 30 mA in the electrical
circuit of your bathroom. Ask your
electrician for advice.
7 Always disconnect the power sup-
ply unit if the appliance is not being
charged or used.
7 Never use the appliance if it is vis-
ibly damaged.
7 Keep the appliance away from
children.
7 The appliance may not be used
by the following people, including
children: those with limited physi-
cal, sensory or mental capabilities
and also those with a lack of experi-
ence and know ledge. This does
not apply to the latter if they were
instructed in the use of the appli-
ance or if they use it under the
supervision of a person responsible
for safety. Children should always
be supervised to ensure that they
do not play with the appliance.
7 Do not open the appliance under
any circumstances. No warranty
claims are accepted for damage
resulting from improper handling.

18 ENGLISH
OVERVIEW _______________________________
Dear customer,
Congratulations on the purchase of
your MT 6742 multi-hair trimmer.
Read the following user notes carefully
to ensure you can enjoy your quality
product from Grundig for many years
to come.
The high-quality and professional
styling appliances in the new product
range fulfil the highest standards for
salon results at home.
A responsible approach!
GRUNDIG focuses on
contractually agreed
social working conditi-ons
with fair wages for both
internal employees and
supp-liers, as well as on the efficient
use of raw materials with continual
waste reduction of several tonnes of
plastic each year – and availability of
at least 5 years for all accessories.
For a future worth living.
For a good reason. Grundig.
Controls
See the illustrations on pages 2 and 3.
A Professional cutting head made
from ceramic/stainless steel
(width 38 mm)
B Side catches for removing attach--
ments
C On/off switch
D Charging display (LED). Lights
up red when charging and green
when it is fully charged
E Socket for plugging into the
charging unit or connecting the
power supply unit
F Charging unit

ENGLISH 19
OVERVIEW _______________________________
Accessories
1 Six comb attachments for to vari--
ous cutting lengths
6 (2 to 20 mm), suitable for both
cutting heads
7 Attachment for thinning out hair
8 Shaving attachment with single
blade foil for a smooth shave
9 Beard trimming attachment
(width 30 mm)
Power supply unit
Cleaning brush
Oil
Comb
Storage case

20 ENGLISH
POWER SUPPLY ___________________________
Rechargeable battery
operation
When operating the appliance with
the built-in nickel metal hydride battery,
only use the power unit supplied for
charging.
Check that the voltage indicated on the
type plate of the power supply unit cor-
responds to your local power supply.
1 Plug the power cord into the appli-
ance socket E and the power
supply unit into the wall socket.
Notes
7 Charge up the batteries completely
before you use them for the first time
or if you have not used them for a
long time (approx.
24 hours timer-controlled charging).
– The charging display D lights up
red when charging and changes
to green when it is fully charged.
7 After the batteries are first char-
ged, the charging time is approx.
12 hours when the appliance is
switched off. If you switch on the
appliance while it is charging, charg-
ing will stop.
– The charging display D goes out.
7 The ambient temperature should be
between 5 °C and 40 °C.
7 When fully charged, the applian-ce
works for about 40 to 60 minutes.
This depends on the attachment being
used. It is not advisable to charge the
batteries after every use, especially if
you do not use the appliance for the
full 30 minutes.
Charge the batteries at your con-
venience only when they are com-
pletely discharged. This increases
their service life. Avoid charging
every day.

ENGLISH 21
POWER SUPPLY ___________________________
Using the charging unit
1 Plug the socket E of the appliance
into the charging unit.
2 Plug the power cord into the socket
on the charging unit.
3 Plug the power supply unit into the
wall socket.
Mains operation
(with the power supply
unit)
Check that the voltage indicated on the
type plate of the power supply unit cor-
responds to your local power supply.
The only way to disconnect the appli-
ance from the power supply is to
unplug the power supply unit.
1 Insert the power cord into the
socket E on the appliance.
2 Plug the power supply unit into the
wall socket.
Caution
7 When in the bathroom or next to a
water connection, you must only use
the appliance in battery mode; never
run it from the mains.

22 ENGLISH
Cutting hair ...
... using the ceramic/stainless steel cut-
ting head A (width 38 mm).
1 If necessary, remove the attachment
by pressing in both side catches B
and lifting off.
2 Insert ceramic/stainless steel cutting
head A carefully at the top and
press down until it clicks into place.
3 Place a towel around the neck and
shoulders of the person whose hair
you are trimming.
OPERATION ______________________________
4 Make sure the person is seated so
that their head is roughly at your
eye level. Before trimming, comb
the hair so that it falls naturally and
you can see the direction in which it
grows.
5 Press the C button to switch on the
appliance.
6 Begin use.
7 Press the C button to switch off the
appliance after use.

ENGLISH 23
Beard trimming ...
... using the beard trimming attachment
9 (width 30 mm).
1 If necessary, remove the attachment
by pressing in both side catches B
and lifting off.
2 Insert beard trimming attachment
9 carefully at the top and press
down until it clicks into place.
3 Loosen the beard hair by combing
the beard in the direction the hair
grows.
4 Press the C button to switch on the
appliance.
5 Begin use.
6 Press the C button to switch off the
appliance after use.
Trimming hair or beards to a
certain length ...
... using the comb attachments 1 to
6.
1 If necessary, remove the attachment
by pressing in both side catches B
and lifting off.
2 Insert attachment A (width
38 mm) or 9 (width 30 mm) care-
fully at the top and press down until
it clicks into place.
Comb #1
Comb #2
Comb #3
Comb #4
Comb #5
Comb #6
Comb #7*
2 mm
4 mm
8 mm
12 mm
16 mm
20 mm
* is designed for thinning out hair.
OPERATION ______________________________

24 ENGLISH
Note
7 The comb attachments fit both cutting
heads.
3 Push the comb attachment carefully
and firmly onto the rounded rear
half of the cutting head from above
and let it click into place.
4 Press the C button to switch on the
appliance.
5 Begin use.
6 Press the C button to switch off the
appliance after use.
7 After use, remove the comb attach-
ment 1 to 6 by pressing the
locking tab at the back and remov-
ing the comb attachment.
Thinning out hair ...
... using the comb attachment 7 (thin-
ning to a length of 2 mm).
1 If necessary, remove the attachment
by pressing in both side catches B
and lifting off.
2 Insert attachment A (width
38 mm) or 9 (width 30 mm) care-
fully at the top and press down until
it clicks into place.
3 Push the comb attachment 7 care-
fully and firmly onto the rounded
rear half of the cutting head from
above and let it click into place.
4 Press the C button to switch on the
appliance.
5 Begin use.
6 Press the C button to switch off the
appliance after use.
7 After use, remove the comb attach-
ment 7 by pressing the locking
tab at the back and removing the
attachment.
OPERATION ______________________________

ENGLISH 25
OPERATION ______________________________
Close shaving ...
... using the shaving attachment 8.
1 If necessary, remove the attachment
by pressing in both side catches B
and lifting off.
2 Insert shaving attachment 8 care-
fully at the top and press down until
it clicks into place.
3 Press the C button to switch on the
appliance.
4 Begin use.
5 Press the C button to switch off the
appliance after use.
Note
7 Do not apply strong pressure when
shaving, as this could damage the
single blade foil.
Note
7 You can remove the single blade
foil of the shaving attachment. To do
this, press both side catches on
the shaving attachment. Clean the
blade head with the cleaning brush
supplied.

26 ENGLISH
CLEANING AND CARE _____________________
Cleaning and care
7 Switch off the appliance and unplug
the power supply unit from the
mains.
7 Remove the attachment and clean
the blade head with the brush sup-
plied.
Caution
7 If cleaning with the brush is not suf--
ficient, you can also rinse the attach-
ment under running water. However,
only do this once the attachment has
been removed.
7 The cutting head on the attachment
does not normally need to be oiled.
If you clean the attachment under
running water regularly but you
also want to maintain the original
condition of the cutting head for as
long as possible, it is worth oiling
it at regular intervals with the oil
provided.
7 Use a soft, dry cloth or the brush sup--
plied to clean the appliance housing
and the charging unit.
Caution
7 Never put the appliance, charging
unit or power supply unit in water or
any other liquid.
7 Before using the appliance again,
ensure that all attachments have
been carefully dried using a soft
towel.
7 Do not use cleaning agents.
Note
7 Remove any clippings after each
use.
Storage
If you do not want to use the appliance
for a long period of time, please store
it carefully.
1 Make sure it is unplugged, has
completely cooled down and all
the accessories are completely dry.
2 Store the parts in the original box in
a cool, dry place.
3 Make sure the appliance is kept
out of reach of children.

ENGLISH 27
INFORMATION ___________________________
Technical data
This product fulfils the Europe-
an directives 2004/108/EC,
2006/95/EC and
2009/125/EC.
Power supply
Batteries: Nickel metal hydride
Mains adapter:
100 – 240 V˜, 50/60 Hz
3.4 V DC 1000 mA
Ni-MH
Technical and design modifications
are reserved.
Environmental note
This product has been made from high-
quality parts and materials which can
be re-used and recycled.
Therefore, do not dispose of
the product along with nor-
mal household waste at the
end of its service life. Take it
to a collection point for the
recycling of electrical and electronic
equipment where the batteries are
taken out of the device and disposed
of separately. This is indicated by this
symbol on the product, in the operating
manual and on the packaging.
Please find out about collection points
operated by your local authority.
Help protect the environment by recy-
cling used products.

Grundig Intermedia GmbH
Beuthener Strasse 41
90471 Nürnberg
www.grundig.com
72011 908 2500 12/48
AUS GUTEM GRUND