Gtech Advanced Power Sweeper User manual

OPERATING MANUAL
Advanced Power Sweeper
Model number:
SW02

4
Thank you for choosing a Gtech Power Sweeper
“I started Gtech to create sensible, easy to use products, which do a great job. Your
opinion is important to us and we will use your feedback to improve our products and
services and let other people know what it’s like to be part of the Gtech family.”
Nick Grey – Inventor, Owner of Gtech
Please take the time to write a review of the Gtech Sweeper by visiting
www.gtech.co.uk/product-reviews or if you didn’t purchase directly from Gtech please
leave a review with the retailer.
What’s in the box
1
Sweeper
Upper Handle
Telescopic Handle Tubes
Lower Handle
Charger (inside dust tray)
Duster
Duster clip
3
4
5
6
7
4
5
6
7
1
2
3
2
Make a note of your product serial number code for future reference. You can nd
this on the underside of item
_ - _ _ - _ _ _ ~
_ _ _ _ _ ~
_ _ _ _ ~
_ _ ~ _ _ _ _ _ _ _
X-XX-XXX~
XXXXX~
WWYY~
00~0000000
1

5
Place the lower handle into the socket.
Push the locking clip back into place.
Push handle forward.
Assembly
To assemble the lower handle
Pull out the locking clip.
The three parts of the telescopic handle
also click into place. The duster can be
clipped onto the back of the handle.

6
Pull back the handle and press the “on”
button with your foot.
Remove the dust tray by pinching the
window slightly, and pulling out.
Normal operation
Push at over the oor.
Deeper cleaning
Lift the handle to lower the
brush bar into the carpet.
Tip the dirt into the bin. If you need to you
can wipe the tray clean with a dry cloth.
Operation
Emptying the bin

7
Remove the telescopic handle by pressing
the button at the front of the lower handle
and pulling the tube out.
The telescopic handle can now be
attached to the duster.
Remove the visor by unclipping the bottom
outer edges at the same time then lifting off.
Push lower handle fully forward.
Use on stairs, starting at the top and
front of each step then moving down and
towards you.
Removing telescopic handle and using duster
Handheld use and stair cleaning

8
Recharging
From time to time you may need to remove
hair and thread from the brush bar. Take off
visor and use a pair of scissors to remove
the hair.
Try to avoid carrying the sweeper ‘nose
down’ as you risk spilling dirt from the
dust tray.
Plug in the charger and connect the jack to
the socket at the rear of the sweeper. A full
recharge will take 16 hours. Do not charge
for longer than 24 hours.
Clearing the brush bar Carrying
The light will show red while the sweeper is
charging and green while it is running.

9
Locate the battery cover. Lift off the battery cover.
Lift out the battery pack. Straighten up the
cable connectors so you can handle them
more easily.
Slide plastic cover off the BLACK cable
connector ONLY. Leave cover on the red
cable connector.
Changing the battery

10
Gently press down xing latch on cable
connector.
Repeat the previous two steps for the
RED wire.
Re-attach the wires to the new battery,
attaching the BLACK wire rst. Fold the
terminals back along the battery.
Put the battery back into the compartment
and replace the cover.

11
Product Care
Troubleshooting
Your Gtech sweeper doesn’t need much maintenance: empty the dust tray, remove hair
and bre from the brush bar and edge wheel and charge the battery. Wipe it with a dry
cloth if it gets dirty, including in and around the bin. Never wash it with liquid or run it
under a tap. Avoid cleaning over rug tassels or frayed carpets as this will tangle the brush
bar. The battery, drive belt, brush bar and side brush are all replaceable items.
If you nd you ever need to replace these items there is an FAQ section on our website at
www.gtech.co.uk
Sweeper is not cleaning well 1. Empty the bin.
2. Remove any build-up of hair from
brush bar and edge wheel.
Sweeper has stopped
or won’t work
1. Fully recharge for 16 hours.
[email protected]Live chat supportOnline How to Videos
Product Support
If these initial tips don’t solve your problem, we have various other ways to help.
Visit: www.gtech.co.uk/support

13
The symbol indicates that this product
is covered by legislation for waste electrical
and electronic products (EN2002/96/EC)
When the sweeper has reached the end of
its life, it and the NiMH battery it contains
should not be disposed of with general
household waste. The battery should be
removed from the sweeper and both should
then be disposed of properly at a recognised
recycling facility.
Call your local council, civic amenity site,
or recycling centre for information on the
disposal and recycling of electrical products.
Alternatively visit
www.recycle-more.co.uk
for advice on recycling and to nd your
nearest recycling facilities.
WARNING: Only use the charger supplied
with the product.
Using another charger may damage the
product and the battery and will invalidate
your guarantee.
FOR HOUSEHOLD USE ONLY
SW02 TECHNICAL SPECIFICATION
Unit operating cycle
with full battery
up to 60 mins
(dependent on oor surface)
Battery type NiMH
Battery voltage 7.2V
Charging period for fully
discharged battery
16 hours
Battery charger output 12V DC, 150mA
Battery charger model JOD-S-120015BS
Sound Level 75db (A)
Weight 1.6kg