GW Instek GRA-445 User manual

Rack Adapter Panel
GRA-445
Assembly Manual
GW INSTEK PART NO. 82RA-44500M01
This assembly manual contains proprietary information, which is protected by copyrights. All rights
are reserved. No part of this manual may be photocopied, reproduced or translated to another
language without prior written consent of Good Will company.
The information in this manual was correct at the time of printing. However, Good Will continues to
improve products and reserves the rights to change specification, equipment, and maintenance
procedures at any time without notice.
Good Will Instrument Co., Ltd.
No. 7-1, Jhongsing Rd., Tucheng Dist., New Taipei City 236, Taiwan.
ISO-9001 CERTIFIED MANUFACTURER

GRA-445 Assembly Manual
GRA-445
Rack Mount Adapter Component List and Assembly
Description
Please check to make sure all the components of the GRA-
445 rack mount kit are provided.
GRA-445
Assembly
Item
Part NO.
Description
QTY
1
62RA-445FP101
CA GRA-445 FRONT
PLATE ,RoHS
1
2
62RA-445HP101
CA GRA-445 L TYPE
HOLDER ,RoHS
1
3
62RA-445LO101
CA GRA-445 BOTTOM
COVER ,RoHS
1
4
594B-W4008NS1
SCREW BMS ,M4*8 ,ISO ,N
(WASHER P.S) ,RoHS
5
5
592B-04016NS1
SCREW
PMS ,+ ,4*16 ,ISO ,N ,RoHS
4
6
62PA-340HD101
CA PA 3U HANDLE, RoHS
2
Assembly
Initial setup
1. Loosen and remove the 2 screws from rear panel of unit.

GRA-445 Assembly Manual
2. Fasten the 2 screws, which were removed from the step 1,
with the holder 62RA-445HP101 on the rear side of unit.
3. Assemble the holding bracket as the figure shown below.
4. Place the unit on top of the holding bracket followed by
fastening them with 2 screws 594B-W4008NS1.