Habitat Nadia NADI-BE-SS18-A User manual

Dimensions
Width - 144/162cm
Height - 95cm
Length - 201/211cm
NADI-BE-SS18-A
Nadia Rattan Bed -135cm/150cm

Safety and Care Advice
Important – Please read these instructions fully before starting assembly
If for any reason you should have
problems with your Habitat product,
please contact the store from which
you purchased it.
Please retain your receipt as proof of
purchase.
If you have any comments or
suggestions regarding this product,
assembly instructions or service
received, please contact the store or
Habitat Head Office via its web site:
www.habitat.co.uk
or write directly to: Habitat Retail Ltd.
489-499 Avebury Boulevard,
Milton Keynes MK9 2NW
General information
Maximum recommended loading.
Do not stand on bed!
MAX
300kg
· This product is designed for indoor use only!
· Take care when moving furniture - dragging it across the floor will loosen and damage the joints.
· Always lift and move
· From time to time check that there are no loose fittings. Tighten as necessary.
· Avoid exposing your furniture to direct and prolonged periods of sunlight and heat sources as fading and
cracking may occur.
· Take care to prevent sharp objects e.g. toys, buckles and heels from coming into contact with your furniture,
and avoid contact with chemicals e.g. cosmetics or hair products which may permanently mark the surface.
· Gently vacuum rattan weave to remove dust build-up
· Wipe up any spills immediately with a damp cloth and then dry the surface with a clean dry duster.
· Repeat this procedure for periodic cleaning.
· Remove stubborn stains with a weak washing up liquid solution and a damp cloth and dry after with a clean cloth.
· The use of furniture polish or spray is not necessary or recommended.
· Never use abrasive or corrosive cleaning agents.
General care and maintence
Cleaning and care
Extra Felt Feet Pads
For Uneven Floors
This product has been
supplied with additional felt
feet pads that can be used
to help level up furniture on
uneven floors.

Components
Please check you have all the components and fittings listed below
If you need help or have damaged or missing parts, email:
customerservic[email protected]o.uk or call: 0344 499 4686
Build Steps
1. Place bed components beside each other
2. Hook connector fittings together securely
3. Carefully place your mattress on top
1
1
2
2
33
4
4