hager 3470 User manual

LATCH LOCKING CAM
LATCH LOCKING CAM
CAM KEYWAY SHOULD FACE
LOCK EDGE OF DOOR
LATCH LOCKING CAM
CAM KEYWAY SHOULD FACE
LOCK EDGE OF DOOR
3670 LEVERSET
USING A SCREWDRIVER, ROTATE THE CAM 1.
CLOCKWISE UNTIL THE CAM PROFILE LOOKS
LIKE THE PICTURE ON THE LEFT.
INSERT THE KEY INTO THE CYLINDER AND 2.
ROTATE THE TAILPIECE 90 DEGREES
CLOCKWISE.
HOLD THE KEY IN THE POSITION FROM STEP 3.
2 AND INSTALL THE LEVER UNTIL IT SNAPS
INTO PLACE.
USING A SCREWDRIVER, ROTATE THE CAM UNTIL 1.
THE KEYWAY FACES THE LOCK EDGE OF THE
DOOR.
INSERT KEY INTO THE CYLINDER AND ROTATE 2.
THE KEY 90 DEGREES SO THE TAILPIECE
MATCHES THE CAM PROFILE.
HOLD THE KEY IN THE POSITION FROM STEP 2 3.
AND INSTALL THE LEVER UNTIL IT SNAPS INTO
PLACE.
REPEAT STEPS 1-3 FOR THE OPPOSITE SIDE OF 4.
THE LOCK.
3470/3570/3473/3573/3579 LEVERSET
3495 LEVERSET
USING A SCREWDRIVER, ROTATE THE CAM UNTIL 1.
THE KEYWAY FACES THE LOCK EDGE OF THE
DOOR.
INSERT KEY INTO THE CYLINDER AND ROTATE 2.
THE KEY 90 DEGREES SO THE TAILPIECE
MATCHES THE CAM PROFILE.
HOLD THE KEY IN THE POSITION FROM STEP 2 3.
AND INSTALL THE LEVER UNTIL IT SNAPS INTO
PLACE.
3470/3473/3495/3570/3573/3579/3670 LEVERSET TIMING INSTRUCTIONS
REV: 08 DRAWING NO: I-LS00310 SHEET 1 OF 2
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 - [phone] - Fax [phone]

LATCH LOCKING CAM
LEFT HAND & LEFT HAND REVERSE MOUNTING - USE A SCREWDRIVER TO ROTATE THE CAM SO THE KEYWAY 1.
FACES UP.
RIGHT HAND & RIGHT HAND REVERSE MOUNTING - USE A SCREWDRIVER TO ROTATE THE CAM SO THE KEYWAY 2.
FACES DOWN (SHOWN IN DETAIL A).
INSERT THE PACKAGED TAILPIECE INTO THE IC CORE CYLINDER. 3.
USING THE CONTROL KEY, INSERT THE IC CORE CYLINDER INTO THE LOCKSET LEVER UNTIL IT SITS FLUSH. 4.
REMOVE THE CONTROL KEY 5.
DETAIL A
LEFT HAND / LEFT HAND REVERSE SHOWN
RIGHT HAND / RIGHT HAND REVERSE
3570/3573/3579 IC LEVERSET TIMING INSTRUCTIONS
REV: 08 DRAWING NO: I-LS00310 SHEET 2 OF 2
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 - [phone] - Fax [phone]