Haier CommercialCool CPF10XCL-LW User manual

IMPORTANT POINTS ON SERVICE OPERATING SAFETY
Please follow these instructions carefully :
FLOW CHART FOR INSPECTING AND REPAIRING THE UNIT
- 1 -
Unplug the unit to avoid any danger from electric shock before disassembling the unit for
repair.
If there is any sound of the refrigerant circulating when in operation, avoid touching the
cooling coils.
If you need to perform any welding or soldering, be sure you are in a well ventilated area.
Only a qualified professional should perform any welding on the unit.
When repairing the unit, the specifications listed in this manual must be strictly adhered
to when replacing any components.
When replacing any electrical components they should be factory approved units.
Be sure that any electrical components are properly wired and in place.
PLUG AND SOCKET
ARE LOOSE
RE-PLUGING THE
POWER SUPPLY CORD
AIR CONDITIONER
WON'T COOL
PROPERLY
AIR CONDITIONER
WON'T START
COMPRESSOR WON'T
START
TIMER FAILURE
CHANGE THE
PROTECTOR
RUNNING TEST
RE-CONNECTING
NO POWER
PROTECTOR FAILURE
USE OXYACETYLENE AND PLUS 5%
SILVER SOLDER TO WELD THE
CRACKED POINTS
WIRING IS LOOSE
CAPACITOR FAILURE
CHANGE THE SWITCH
CHANGE THE
CAPACITOR
TESTING BY
ELECTROSCOPE
POWER TRIPPED CHECK THE POWER
SWITCH
REFRIGERANT
LEAKAGE
TROUBLE SHOOTING
THE SYSTEM
RUNNING THE VACUUM
EVACUATION FOR MORE
THAN 15 MINUTES
CHANGE COOLANT AND
PROCEED RUNNING TEST
CHANGE THE AIR CONDITIONER WITH 15 KG/CM 2
NITROGEN GAS FROM LOW-PRESSURE SIDE AND
DETECT THE LEAKING POINT BY SOAP

TROUBLESHOOTING
Problem
- 2 -
Analysis
Does not run
·If the protector trip or fuse is blown.
·Please wait for 3 minutes and start again, protector
device may be preventing unit to work.
·If batteries in the remote controller exhausted.
·If the plug is not properly plugged.
Run a short while
only
Run but not cool
Do not run and water
full indicator lights
·If the set temperature is close to room temperature,
you can low the set temperature.
·Air outlet be blocked by obstacle.
Take the obstacle away.
·If the door or window open.
·If there is other heater appliance work,
like heater or lamp, etc...
·The air filter is dirty, please clean it.
·Air outlet or intake be blocked.
·Set temperature is too high.
·Drain the water into a prepared container by the drainage
pipe on the rear panel of the unit.
If still doesn't work, please consult a qualified technician.

APPEARANCE
- 3 -
Control panel
Wheels
Air exhaust for air to be
cooled/filtered
Front Panel
Handles
Air inlet for air to
be cooled / filtered
Air outlet
Air filter
Electricity cable Water drain
Air inlet
UNIT DIMENSIONAL
450 393
746

OPERATION
- 4 -
Power Control
The power control turns the unit on and off.
Warning Light
Condensed water may accumulate in the unit. If
the internal tank becomes full, the Warning Light
will shine and the unit will not operate until the
unit has been drained.
Mode Control
The Mode Control has three settings:
● Cool ● Dehumidify ● Fan
The settings are adjusted with Mode Control
button. A light will indicate which setting is
currently being used.
● Cooling Mode
When cool mode is selected, the indicator light
will shine blue. During the cooling mode the
air is cooled and hod air is exhausted to the
outside air through the exhaust tube. Adjust fan
speed air through the temperature to suit your
desired comfort level.
Note : The air exchange hoses must vent
outside the room when using cool mode.
● Fan Mode
When fan mode is selected the indicator light will
shine green. Air is circulated throughout the room
with no cooling.
Note: unit does not need to be vented in Fan
mode
Fan Speed Control
The Fan Speed Control has 3 settings: High, Medium,
and Low.
Timer
Auto turn off :
With machine in fan mode, press timer button to select
number of hours you would like the unit to run in air
conditioning mode until it automatically shuts off.
Auto turn on :
With machine powered off , press timer button to
select number of hours until you would like the unit
to automatically start running in air conditioning mode.
Timer / Temp set controls
● Used for adjusting the timer and thermostat.
● The default display is room temperature.
● In cooling mode, when " " or " " button is
pressed, the set temperature is displayed and may
be adjusted. After 15 seconds the display will revert
back to room temperature. Temperature is only
adjustable in cool mode. The time is adjustable
between 1~12 hours.
Note : By pressing both Timer / Temp set buttons at
the same time, the display will toggle between
Celsius and Fahrenheit.
H
M
L
Warning Light
Power Control
Mode Control
Fan Speed Control
Display
Timer / Temp
Set Controls
Timer
● Dehumidify Mode
When dehumidify mode is selected, the indicator
light will shine yellow. Air is dehumidified as it
passes through the unit, without being in full
cooling mode. The fan will operate in med speed.
Fan speed is not adjustable in dehumidify mode.
Note : The air exchange hoses must vent
inside the room when using dehumidify mode.

OPERATION
- 5 -
CONTROL PANELCONTROL PANEL
Battery replacement : Remove the cover on the back of the remote control and insert the batteries with the
( + ) and ( - ) poles pointing in the proper direction.
CAUTION
Use only AAA or IEC R03 1.5V batteries.
Remove the batteries if the remote control is not used for a month or longer.
Do not attempt to recharge the supplied batteries.
All batteries should be replaced at the same time, do not mix old battery .
Do not dispose of the batteries in a fire as they may explode.
！！
Fan Speed ControlFan Speed Control
Time / Temperature Set Control
Power ControlPower Control
On / Off
On / Off Timer ControlOn / Off Timer Control
In running mode :
Auto switch off
In stand-by mode :
Auto switch on
Press " " or " " button
to adjust the time setting
for 1 hour interval.
:HIGH :MED :LOW
● Used for adjusting the timer and
temperature.
● The default display on control panel is
room temperature.
● When " " or " " key is pressed in
cool mode, the set temperature is
displayed and may be adjusted. After
15 seconds the display will revert back
to room temperature.
Air Conditioner Remote Control
The functions work the same as your air conditioner's touch controls.
All key function can be accessed from the remote control.
● Timer setting is available from 1-24 hours
by pressing the key " " on " ".
Notes
- Do not drop the remote control.
- Do not place the remote control in a
location exposed to direct sunlight.
- The remote control should be placed
about 1 meter or more away from TV,
or any electical appliances.
1.5V1.5V
1.5V1.5V
Mode ControlMode Control
Press this button to change the
operation mode in the order of :
Cool Dehumidify
Fan

TECHNICAL SPECIFICATIONS
- 6 -
ITEM UNIT
OUTER DIMENSION
RATED VOLTAGE
COOLING
DEHUMIDIFYING
CAPACITY
INDOOR AIR VOLUME
COMPRESSOR
MODEL
OUTPUT
POWER
OPERATING
CYCLE
PROTECTOR
MODEL
INPUT
POWER
TURBINE
FAN MOTOR
CAPILLARY
CONDENSER
REFRIGERANT
WEIGHT
REFERENTIAL USING
AREA
450W*730H*380D
115 / 60
300
920
30/300
WT-15T1-03
15
9/250
2.6(O.D.)*1.2(I.D.)*700(L)
2R16S21FPI
WAP-297ES (HAIER CPF10XCL-LW)
10000
10~19
1.4
30.5
OPERATING
CYCLE
MODEL
OUTPUT
POWER
INDOOR
MOTOR
LS-16T3-02
16
4/250
OPERATING
CYCLE
MODEL
OUTPUT
POWER
OUTDOOR
MOTOR
LS-53T1-4P
53
EVAPORATOR 2R12S15FPI
mm
2
m
V/Hz
B.T.U.
L/H
3
M /hr
W
uF/V
mm
uF/V
R410A/g
kg
W
uF/V
W
W
41T086-A2-BMAC
MRA12285-12082
440
RUNNING CURRENT A9.5

TECHNICAL SPECIFICATIONS
- 7 -
ITEM UNIT
OUTER DIMENSION
RATED VOLTAGE
COOLING
DEHUMIDIFYING
CAPACITY
INDOOR AIR VOLUME
COMPRESSOR
MODEL
OUTPUT
POWER
OPERATING
CYCLE
PROTECTOR
MODEL
INPUT
POWER
TURBINE
FAN MOTOR
CAPILLARY
CONDENSER
REFRIGERANT
WEIGHT
REFERENTIAL USING
AREA
450W*730H*380D
115 / 60
300
993
55/300
WT-15T1-03
15
9/250
2.6(O.D.)*1.2(I.D.)*700(L)
(2+1)R16S21FPI
WAP-357ES (HAIER CPF12XCL-LB)
12000
11~20
1.6
31
OPERATING
CYCLE
MODEL
OUTPUT
POWER
INDOOR
MOTOR
LS-16T3-02
16
4/250
OPERATING
CYCLE
MODEL
OUTPUT
POWER
OUTDOOR
MOTOR
LS-53T1-4P
53
EVAPORATOR 3R12S15FPI
mm
2
m
V/Hz
B.T.U.
L/H
3
M /hr
W
uF/V
mm
uF/V
R410A/g
kg
W
uF/V
W
W
44N100-A2-BCAD
B470-135-241C
580
RUNNING CURRENT A10.8

SCHEMATI C WIRING DIAGRAM
- 8 -
REFRIGERATOR SYSTEM DIAGRAM
EVAPORATOR
CONDENSOR
COMPRESSOR
CAPILLARY
FILTER
CN1
BROWN
BLUE
GREEN/
YELLOW
AC CORD
A6957-400