Haier HRT02WNC User manual

Comps@ _÷friger_ted Coo_÷r
Ceng@_te_r Cemp_¢t
Cenge_der Cemp_@@
User Manual
HRT02WNC!HRT03WNC
Guide de J'Utilisateur
HRT02WNC!HRT03WNC
ManuaJ del Usuario ModeJo
HRT02WNC!HRT03WNC

When using this appliance, always exercise basic safety precautions,
including the fdlawing:
1) Use this appliance only for its intended purpose as described in this use
and care guide.
2) This refrigerated cooler must be properly installed in accordance with the
installation instructions before it is used. Seegrounding instructions in the
installation secfion_
3) Never unplug your refrigerated coder by pulling on the power cord.
Always grasp the plug firmly and pull straight out from the outlet.
4) Repair or replace immediately, all electric servicecords that have becorne
frayed or otherwise damaged. Do not use a cord that showscracks or
abrasion darnage along its length, the plug or the connector end.
s)
6)
7)
Unplug your refrigerated coder before cleaning or before making any
repairs_
Note:If for any reason this product requires service,we strongly recommend
that a cedified technician performs the service.
Do not use any dedrical device or any sharp instrument in defrosting your
refrigerated coolen
If your old refrigerated coder is not being used, we recommend that you
remove the doors and leavethe shelvesin place. This will reducethe possi-
bility of danger to children.
8) After your refrigerated coder is in operation, do not touch the cold sur-
faces in the refrigerated coder compartment, padicularly when hands
are damp or wet. Skin may adhere to these extremely cold surfaces.
9) This refrigerated coder should not be recessedor buiJtdnan endosed cabi-
net. It isdesigned for freestanding installation only_
10) Do not operate your refrigerated coder in the presence of explosive
furnes_
11) It is not recornrnended to store foods which rnust be kept at below 40° F
for safe storage_ This includes most dairy, meat and risk
SAVE THESE INSTRUCTIONS

DANGER
Thank you for using our Haier
product_ This easy-to-use manual
will guide you in getting the best
use of your refrigerated coden
Remember to record the model and
serial number. They are on a label
in back of the refrigerated cooler_
Model number
Serial number
Date of purchase
Staple your receipt to your rnanuak
You will neocl it to obtain warrant,/sorvico.

PAGE
Safety Precautior_s .......................................................................... 1
Parts And Features .......................................................................... 4
Jr_staJling Your Refrigerated cooler ................................................ 5
Unpacking Your Refrigerated cooler ...................................................... 5
Proper Air Circulation .......................................................................... 5
Electrical Requirements ........................................................................ 5
Use of Extension Cords ........................................................................ 6
Install Limitations .................................................................................. 6
Door AJignment .................................................................................. 6
RefrigeratecJ ¢aomer Features And Use .............................................. 7
Generd Features ................................................................................ 7
Proper J_efrigerated cooler Care arid CJeaning ............................ 8
CJeaning and Maintenance .................................................................. 8
Power Interruptions .............................................................................. 8
Vacation and Moving Care .................................................................. 8
lrroubJeshooting .............................................................................. 9
Warranty Jnformatior_ .................................................................... 10

J
1. Full Width Shelves
2. Air Circulation Fan
3. Temperature Control
4. Drain Reservoir
5. 1 Full and I Half Width Door
Storage Shelves
6. Water Collection Pan (in the back)

1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the refrigerated cooler accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the refrigerated cooler.
P_ope_ A_ Ci_¢o_tio_
" To assure your refrigerated cooler works at the maximum efficiency it was
designed for, you should install if in a location where there is proper air
circulation, plumbing and electrical connections.
The following are recommended clearances around the refrigerated cooler:
Sides ............... 2 "(50ram)
Top .................... 2" (50mm)
Back .................. 4" (100mm)
IIIE_e@_c_ _equ_e_e_ts
" Make sure there is a suitable power Outlet (1 !5 volts, 15 amps outlet) with
proper grounding to power the refrigerated cooler.
" Avoid the use of three plug adapters or cutting off the third grounding in order
to accommodate a two plug outlet. This is a dangerous practice since it
provides no effective grounding for the refrigerated cooler and may result in
shod< hazard.

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii ii i!ill
Use e_ IIIl!!!x_e_sioH Co_d
" Avoid the use of an extension cord because of potential safety hazards under
certain conditions. Jf it is necessary to use an extension cord, use only a 3-wire
extension cord that hasa 3-bladegrounding plug anda 3-dot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
I_st_/ Limit_tioHs
Do not install your refrigerated cooler in any location not properly insulated or
heated e.g. garage etc. Your refrigerated cooler was not designed to operate
in temperature settings below 55 ° Fahrenheit.
Select a suitable location for the refrigerated cooler on a hard even surface
away from direct sunlight or heat source e.g. radiators, baseboard heaters,
coddng appliances etc.
Your refrigerated cooler was designes to operate at appropxima_ely 20° - 25 °
below room (ambient) temperature when set at maximum settings.
_@@_ _lig_m@_t (see fig. #1)
1. Remove the top hinge cover by using a flathead screwdriver. Place the head
under the front edge of the cap and gently lift.
2. Loosen the top hinge screws using a Phillips head screw driver.
3. Adiust the door or put a spacer in between and tighten the screws.
4. Replace the fop hinge cover by aligning the rear of the cover with the rear of
the hinge. Press firmly on the front of the cover until it snaps in place.
fig. 1

GeHe_ IIIFeete_es
Your refrigerated cooler will MIN
automatically maintain the
temperature level you select. The
temperature control dial has 6 settings.
The thermostat is divided into 6levels
rain, reed and max with a temperature
setting in between each one. At first,
set the dial to Max for 2 hours before adjusting the temperature to your needs.
Refrige_'e_ed cooler Interior Shelves
To remove or replace a fuJlowidth slideoout shelf: (see fig_ # 2)
1. Gently tilt the shelf up and slide forward until the shelf has been completely
removed.
2. To replace the shelf, gently slide the shelf back.
fig. 2

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
W_r_J_g: To avoid electric shock always unplug your refrigerated
cooler before cleaning. Ignoring this warning may result in
death or injury.
¢_tion: Before using cleaning products, always read and follow
manufacturer's instructions and warnings to avoid personal
iniury or product damage.
Ger_er_J: Prepare a cleaning solution of 3-4 tablespoons of baiting
soda mixed with warm water. Use sponge or soft cloth,
dampened with the cleaning solution, to wipe down your
refrigerated cooler.
Rinse with clean warm water and dry with a soft cloth.
Do not use harsh chemicals, abrasives, ammonia,
chlorine bleach,concentrated detergents, solvents or
metal scouring pads. SOME of these chemicals may
dissolve, darnage and/or discolor your refrigerated cooler.
Door @_sJ{ets: Clean door gaskets every three months according to gen-
eral instructions. Gaskets must be kept clean and pliable to
assure a proper seal.
Petroleum ielly applied lightly on the hinge side of gaskets
will keep the gasket pliable and assure a good seal.
Pewe_ _te_pt_e_s
" Occasionally there may be power interruptions due to thunderstorms or other
causes. Remove the power cord from AC outlet when a power outage occurs.
When power has been restored, replug power cord to AC outlet.
For long vacations or absences, empty food from refrigerated cooler, move the
temperature DIAL to the OFF position and clean the door gaskets according to
"General cleaning" section. Prop doors open, so air can circulate inside. 8

lefrigeralet cooler toes Iol operale:
"Check if thermostat control is not in the "0" position.
Check if refrigerated cooler is plugged in.
Check if there is power at the ac outlet, By checking the circuit Breaker.
Temperature appears too warm:
"Frequent door openings.
Allow time for recently added warm food to reach fresh food temperature.
Check gaskets for proper seal.
Adiust temperature control to colder setting.
Temperature is too ¢o_d:
"If temperature control setting is too cold, adiusf to a warmer setting and allow
several hours for temperature to adiust.
Moisture buld up on interior or e×teHor of _he refrigerated
¢oo_er:
This is normal during high humidity periods.
Prolonged or frequent door openings.
Check door gaskets for proper seal.
Refrigerated cooler has an odor:
"Interior needs cleaning.
Foods improperly wrapped or sealed are giving off odors.
Refrigerated ¢oomer door does not shut properly:
"Re-align refrigerated coder door.
Check for blockages e.g. food containers, crisper cover, shelves, bins etc...