Haier HVD042M User manual

I
What The World Comes Home To _
D
_er Manual° Model#
G_#d_ _ #'U_###sa_r _ Modele
Ma_# _# U$_r#_- ParaModelode

SAFETYPRECAUTIONS
Read all of the instructions before using this appliance.
When using this appliance, always exercise basic safety
precautions, including the following:
1) Use this appliance only for its intended purpose as described in this use
and care guide.
2) This wine cooler must be properly installed in accordance with the
installation instructions before it is used. See grounding instructions in the
installation section.
3) Never unplug your wine cooler by pulling on the power cord. Always
grasp the plug firmly and pull straight out from the outlet.
4) Repair or replace immediately, all electric service cords that have become
frayed or otherwise damaged. Do not use a cord that shows cracks or
abrasion damage along its length, the plug or the connector end.
5) Unplug your wine cooler before cleaning or before making any repairs.
Note: If for any reason this product requires service, we strongly
recommend that a certified technician performs the service.
6) If your old wine cooler is not being used, we recommend that you remove
the door and leave the shelves in place. This will reduce the possibility
of danger to children.
7) This wine cooler should not be recessed or built-in an enclosed cabinet. It
is designed for freestanding installation only.
8) Do not operate your wine cooler in the presence of explosive fumes.
9) Do not store foods in wine cooler as interior temperature may not be cool
enough to prevent spoilage.
SAVETHESEINSTRUCTIONS
ForFutureReference

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!iiiiii
DANGER
Risk of child entrapment. Before you throw away your old
wine cooler, take off the doors. Leave the shelves in place so
that children may not easily climb inside.
As per UL 250 Standards
Thank you for using our Haler
product. This easy-to-use manual will
guide you in getting the best use of
your wine cooler.
Remember to record the model and
serial number. They are on a label in
back of the wine cooler,
Model number
Serial number
Date of purchase
Staple your receipt to your manual. You will need it to obtain
warranty service.

PAGE
Safety Precautions .......................................................................... 1
Parts And Features .......................................................................... 4
Installing Your Wine Cooler .......................................................... 5
Unpacking Your Wine Cooler .................................................................. 5
Leveling Your Wine Cooler ...................................................................... 5
Proper Air Circulation ............................................................................ 5
Electrical Requirements ............................................................................ 6
Wine Cooler Features And Use .......................................................... 7
Initial Set Up .......................................................................................... 7
Temperature Adjustment .......................................................................... 7
Shelving ................................................................................................ 8
Normal Operating Sounds ...................................................................... 8
Proper Wine Cooler Care and Cleaning ...................................... 9
Cleaning and Maintenance .................................................................... 9
Power Interruptions .............................................................................. 10
Vacation and Moving Care .................................................................. 10
Troubleshooting .............................................................................. 11
Warranty Information .................................................................. 12

Located Rear of Unit
Bottom Right
1. Recessed Door Handle
2. Temperature Control (see insert)
3. Adjustable Leveling Legs (not shown)
4, Slide-Out Basket
5, Slide-Out Shelves

Unpacking Your Win÷ Coo er
1, Remove all packaging material, This includes the foam base and all
adhesive tape holding the wine cooler accessories inside and outside,
Slide out and remove plastic or foam guard used to secure the
compressor from shipping damage due to vibration and shock.
2, Inspect and remove any remains of packing, tape or printed
materials before powering on the wine cooler.
Z÷v÷Hng Your Wine Ooo ÷r
• Your wine cooler has four leveling legs which are located in the
front and rear corners of your wine cooler. After properly placing your
wine cooler in its final position, you can level your wine cooler.
• Leveling legs can be adjusted by turning them clockwise to raise your
wine cooler or by turning them counterclockwise to lower
your wine cooler, The wine cooler door will close easier when the
leveling legs are extended.
Proper Air Circulation
• To assure your wine cooler works at the maximum efficiency it
was designed for, you should install it in a location where there
is proper air circulation, plumbing and electrical connections.
• The following are recommended clearances around the wine cooler:
Sides ............... 2 "(50mm)
Top .................... 2" (50mm)
Back .................. 2" (50mm)
• Do not over fill your wine cooler for proper internal air circulation,

Dectrica_ Requirement
Make sure there is a suitable power Outlet (115 volts, 15 amps outlet)
with proper grounding to power the wine cooler.
Avoid the use of three plug adapters or cutting off the third grounding in
order to accommodate a two plug outlet. This is a dangerous practice
since it provides no effective grounding for the wine cooler and may
result in shock hazard,
Limitations
Do not install your wine cooler in any location not properly insulated or
heated e.g. garage etc, Your wine cooler was not designed to operate
in temperature settings below 55 ° Fahrenheit.
• Select a suitable location for the wine cooler on a hard even
surface away from direct sunlight or heat source e.g. radiators,
baseboard heaters, cooking appliances etc, Any floor unevenness
should be corrected with the leveling legs located on the front and rear
bottom corners of the wine cooler.
• Your wine cooler is designed for free-standing installation only. It is not
designed for built-in application.

Initial Setup
• The control for this is on the back of the unit. There are 6 settings
plus 0 (OFF), Initially set the temperature setting to 3, Let the unit run for
at least 30 minutes to acclimate itself before making any adjustments,
T÷mperatur÷ Adjustment (Seer_g.# 1)
• Your wine cooler has a temperature control knob on the back of the
unit, There are 6 settings: 1 being the warmest and 6 being the coolest,
You can set the temperature of your wine cooler at any setting you
desire, The wine cooler is designed to maintain a temperature between
39°F to 65°F.
fig. # 1

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i!i!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii
• The shelves are designed for flexibility and easy cleaning.
To accommodate different sized bottles the shelves slide out
and can be moved up or down into any of the tracks molded
into the cooler cabinet. Larger bottles or Magnums can be more easily
accommodated on the cross shelves of the bottom basket of the cooler,
You will notice that the shelves are designed so the bottles do
not line-up directly over one another. This allows free air
movement and provides more space.
Norma_ Op÷rating Sounds You May H÷ar
• Boiling water, gurgling sounds or slight vibrations that are the result of
the refrigerant circulating through the cooling coils,
• The thermostat control will click when it cycles on and off,

CMeaning and Maintenana÷
Warning: To avoid electric shock always unplug your
wine cooler before cleaning. Ignoring this warning
may result in death or injury.
Caution: Before using cleaning products, always read and
follow manufacturer's instructions and warnings to
avoid personal injury or product damage,
General:
• Prepare a cleaning solution of 3-4 tablespoons of
baking soda mixed with warm water. Use sponge or
soft cloth, dampened with the cleaning solution, to
wipe down your wine cooler.
• Rinse with clean warm water and dry with a soft cloth.
• Do not use harsh chemicals, abrasives, ammonia,
chlorine bleach,concentrated detergents, solvents or
metal scouring pads. SOME of these chemicals may
dissolve, damage and/or discolor your wine cooler.
Door Gaskets: Clean door gaskets every three months according to
general instructions, Gaskets must be kept clean and
pliable to assure a proper seal,
• Petroleum jelly applied lightly on the hinge side of
gaskets will keep the gasket pliable and assure a
good seal.
9