Hairy Bikers SDA1073 User manual

IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed. These instructions should be saved for future
reference:
Read and familiarise yourself with all operating instructions before using
this Power Juicer.
Before plugging your unit into the mains, visually check that it is intact and
has not suffered any transit damage.
Check that the voltage indicates on the data plate corresponds with that of
the local network before connecting the appliance to the mains power
supply.
Do not use this product with a programmer, timer, separate remote-control
system or any other such device.
Do not immerse this appliance in water or any other liquids.
Close supervision is required when using this appliance near children.
Never leave this appliance within reach of children.
This appliance shall not be used by children from 0 to 8 years.
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved.
Children shall not play with the appliance.
Keep the appliance and its cord out of reach of children less than 8 years.
Cleaning and user maintenance shall not be made by children.
Do not leave the appliance unattended during use.
Do not leave the appliance unattended whilst connected to the mains
supply.
Always use this appliance on a solid, level, non-flammable surface.
Do not use this appliance outdoors.
It is imperative to unplug the power cord after the appliance has been
used, before it is cleaned and whilst being repaired.
Regular, periodic checks should be carried out on the supply cord to
ensure no damage is evident. Should there be any signs of damage the
appliance should not be used.
If the supply cord is damaged it is to be replaced by a qualified person in
order to avoid a hazard.
Do not operate this appliance with a damaged plug or cord, after a
malfunction or after being dropped or damaged in any way.
Do not allow the mains cable to hang over sharp edges or come in contact

with hot surfaces.
This appliance is intended for household use only and should not be used
for industrial purposes.
Do not use any accessories or attachments with this appliance other than
those supplied or recommended by supplier.
Do not use this appliance for anything other than its intended use.
Do not push objects into any openings as damage to the appliance and/or
electric shock may occur.
CAUTION: The centrifuge bowl assembly is sharp, handle with care.
DO NOT ATTEMPT TO SHARPEN THE CENTRIFUGE BOWL
ASSEMBLY.
DO NOT use the appliance if the centrifuge bowl assembly is bent or
damaged.
To avoid the risk of injury or damage never place the centrifuge bowl
assembly onto the base without the proper attachment.
Only use attachments and accessories intended for use with this product.
DO NOT overfill
DO NOT operate the appliance while it is empty.
Unplug after each use. Grasp the plug not the cord.
WARNING: Do not wrap the power cord around the appliance
when storing.
Before the first time you use your Power Juicer
Please read these operating instructions thoroughly and keep them in a safe
place for future reference.
Remove all packaging materials and dispose of according to local regulations.
Clean all surfaces with a soft, clean, damp cloth.
Warning: Do not immerse the appliance, cord or plug in water. To remove any
excess dust that may have accumulated during packing, wipe the exterior with
a clean, soft, damp cloth. Do not use harsh or abrasive cleaners on any part of
the appliance.

Description of Parts
1. Tamper
2. Funnel
3. Lid
4. Pulp Collector
5. ON/OFF Switch
6. Motor Section
7. Lock Mechanism
8. Base
9. Juicer Cup with Lid
10. Centrifuge Bowl
6
1
5
2
3
4
9
8
10
7

Instructions for use
Assembly before use:
1. Place the motor section (6) on a flat, level surface and ensure that it is
standing firmly on the four non-slip feet.
2. Place the base (8) onto the motor section so that the spout fits into the slot
on the side of the motor section.
3. Push the fruit pulp collector (4) up under the drain edge on the base so that
it locks onto the foot of the motor section (6).
4. Carefully lock the centrifuge bowl (10) onto the base.
Note: Take care not to touch the sharp edges at the bottom of the
centrifuge bowl.
Ensure the centrifuge bowl sits properly on the base so that the gear
on the bottom of the bowl engages the gear in the base.
Ensure that the centrifuge bowl doesn’t sit too loosely on the base
and that it rotates freely.
5. Place the lid (3) onto the juicer so that it covers both the pulp collector and
the centrifuge bowl. Ensure the lid fits tightly.
6. Turn the lock mechanism (7) to the vertical position and ensure it engages
with the lid and locks tight. (The lock mechanism makes a click sound when
located correctly).
7. Place the juicer cup with lid under the spout.
8. Plug the Power Juicer into a suitable wall socket.
9. The Power Juicer is now ready for use.
Preparing fruit and vegetables for juicing:
Always wash fruits and vegetables thoroughly before juicing.
It is not necessary to remove seeds, pips and thin skins before juicing.
Fruits with thick skins such as oranges or lemons must be peeled before
juicing. (It is important to remove all the skin, including the pith to avoid any
bitter taste in the juice)
It is also important to remove large pips and stones such as in plums and
apricots to avoid damaging the appliance.
Large fruits and vegetables should be cut to a size that will easily fit into
the funnel.

Using the Power Juicer.
1. Start the Power Juicer by turning the ON/OFF switch to position “1” (low
speed) or position “2” (high speed).
2. The low speed setting is suitable for juicing soft fruits and vegetables.
The high speed setting is suitable for juicing harder fruits and
vegetables.
3. Feed the selected fruits and/or vegetables into the centrifuge bowl
through the funnel, a little at a time, pushing them down using the
tamper ( ).
4. Make sure you use the tamper so the groove in the tamper fits into the
funnel correctly.
5. Long vegetables such as carrots should be fed into the funnel narrow
end first.
6. Press the fruits/vegetables gently into the funnel. Too much pressure
can reduce the amount of juice extracted and may also damage the
appliance.
7. To avoid splashes turn off the appliance before removing the tamper to
add more fruits/vegetables.
8. Do not allow the pulp collector to overfill.
9. Always turn the ON/OFF switch to the 0 (OFF) position and remove the
plug from the wall socket before removing the lid.
Tips.
To make cleaning easier, line the pulp collector with a plastic bag before
use.
Use fresh fruits and vegetables – They contain the most juice.
Leafy green vegetables such as cabbage and spinach can be juiced, roll
the leaves up into a cylinder before feeding into the funnel.
Pure apple juice turns brown quickly when exposed to air, if not served
immediately add a little lemon juice to prevent discolouration.
Fruit/vegetable pulp can be added to cakes/muffins/lasagna etcetera.

Cleaning and maintenance
Always unplug the Power Juicer from the mains power supply before
cleaning.
Allow the appliance to cool before cleaning.
Do not clean any part of your Power Juicer in a dishwasher.
Do not submerge ay part of the main body, plug or mains cable in water or
any other liquids.
Empty the pulp collector of excess waste.
The centrifuge bowl, pulp collector and all other detachable parts should be
hand washed in warm soapy water.
Clean the motor unit with a soft damp cloth and dry thoroughly.
Do not clean any part of your Power Juicer with any harsh or abrasive
cleaners.
Electrical Connections
This appliance is fitted with a fused three-pin plug to BS 1363. If the plug
has to be removed, it should be cut off and carefully disposed of
immediately. To avoid a possible shock hazard, do not insert the discarded
plug into a mains socket.
Fitting a new plug
If for any reason you need to fit a new plug, the flexible mains lead must be
connected as shown below. The wires in the mains lead fitted to this
appliance are coloured in accordance with the following code:
Brown wire = Live (L)
Blue wire = Neutral (N)
Connect
Brown to
Live (L)
Connect
Blue to
Neutral (N)
Ensure the outer sheath is
securely held by the cord
clamp

If colours of the wires in the mains lead of this appliance do not correspond
with the coloured marking identifying the terminals in your plug, proceed as
follows:
The wire which is coloured Blue must be connected to the terminal which is
marked with the letter N or coloured Black. The wire which is coloured
Brown must be connected to the terminal which is marked with the letter L
or coloured Red. Before refitting the plug cover check that there are no cut
or stray strands of wire inside the plug. Use a 13 Amp BS 1362 fuse, only
BSI or ASTA approved fuses should be used. If you are in any way unsure
which plug or fuse to use, always refer to a qualified electrician.
Note: After replacing or changing a fuse on a moulded plug which has a
fuse cover, the cover must be refitted to the plug, the appliance must not
be used without a fuse cover.
Technical Data
Voltage: 220-240V 50Hz
Rated Power 850W
Model Number SDA1073
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Hairy Bikers® is a Registered Trade mark.
Produced and imported by Europasonic (UK) Ltd.
Manchester M3 1JS
www.europasonic.com