HAKO Scrubmaster B175 R User manual

Hako Scrubmaster B175 R
Qualified persons only are authorised to operate the machine!
The machine is not designed for coarse material! Floor area sweepin before!
Use only cleaning agents suitable for automatic machines! (low foaming!)
Please pay attention to the informations in the instruction manua!
11
8
4
3
1
6
OPERATION
1. Unplug the charging cable and put it in its box 1
2. Fill the clear water tank from opening 2. ( max 0° C ). Multifunction display (MFD) 3
shows the water level at 20%:n intervals.
3. Switch the machine on by the key switch 4and actuate driving direction from button .
4. Press green button 6to lower brush head 7 and squeegee 8, suction turbine swithes on.
. Press pedal 9, machine moves and brush head drive switches on. Use knob 11 to adjust
the water level in MFD 10 (if necessary)
NOTE! Make sure that pads / brushes are installed!!
Installing the bruhes: Place the brushes under the brush head in the correct positions, sit on
the bench and use knob 11 in MFD to select the brush attachment icon 12 and press the
knob, press the knob again to confirm selection 13. Wait until the brushes are engaged 14
7
9
10
2
12 13 14

Hako Scrubmaster B175R
7
11
2
4
1
9
Daily maintenance
Empty clear water tank from hose 1
Empty soiled water tank from hose 2and
clean soiled water tank 3.
Check suction filter 4and take off and clean if
necessary. Clean lid sealing
Remove suction hose 6 and clean it
Turn the squeegee 7 by grabbing the yellow handles
with both hands and pull the squeegee upwards with a
single pull, the swivel mechanism is released, rotate the
squeegee 90° or remove squeegee and clean it, check
sealing strips.
Lift up and open the wipers 8and remove brushes /
pads selecting the brush removal icon 9on the MFD with
the knob and press the knob. Accept the selection 10 by
pressing the knob again and clean brushes/pads and
check them for wearing.
Charge battery
MAINTENANCE AND CARE
Weekly maintenance
Check and clean brush head and
wipers sealing strips 8and turn them or
replace them if necessary.
Clean the machine from outside
Open and check clear water filter 11
Clear water tank thorough
emptying/maintenance from opening 12
Check squeegees sealing strips 13 and
turn or replace the if necessary
check the acid level of the battery,
demineralized water must be refilled if
necessary.
Suction result is bad
osuction filter 4, suction hose 6or
squeegee 13 is blocked.
oLocking cap of soiled water drain hose
2 is open.
oTank lid sealing is defect or tank lid is
open
3
6
8
10
13
12
Turn off the machine before maintenance!
Please pay attention to the informations in the instruction
manual, you can find manual by reading QR-code.