
3
Note – Capacity
•The capacity is always shown when the Power Pack is charging.
•Each status LED corresponds to 25% of the capacity. When an LED is permanently illuminated, this
indicates that this capacity level has already been reached. The Power Pack is charged to at least
75% if three LEDs are illuminated, and the fourth is ashing.
•If all four status LEDs light up, the full capacity is available.
•Press the button of the Power Pack to switch it on and to check its current capacity.
•To switch the power pack off, press the button twice until the status LEDs go out.
Warnung – Battery
•Only use suitable charging devices or USB connections for charging.
•As a rule, do not charge devices or USB connections that are defective and do not try to repair them
yourself.
•Do not overcharge the product or allow the battery to completely discharge.
•Avoid storing, charging or using batteries in extreme temperatures.
•When stored over a long period of time, batteries should be charged regularly (at least every three
months).
4.2 Charging terminal devices
•Connect the included Micro-USB charging/connecting cable to the USB port on the power pack
(OUT 1 5V/2.1A / OUT 2 5V/2.1A) and to the Micro-USB port on your terminal device (mobile
phone, smartphone, etc.).
•The Micro-USB charging/connecting cable included may not be suitable for the USB connection on
your terminal device. In this case, use the USB cable that was included with your terminal device.
•Charging begins automatically. The status LEDs show the remaining capacity when the Power Pack
is charging.
•The current battery status of your terminal device will appear on this device.
•Press the button on the power pack twice to stop charging and switch it off. The status LEDs
should switch off.
•The Power Pack will automatically switch off if it is not connected to a terminal device.
Warning – Connecting terminal devices
•Before connecting a terminal device, check whether the power output of the charger can
supply sucient power for the device.
•Ensure that the total power consumption of the connected terminal device does not exceed
2100 mA.
•Please refer to the instructions in the operating manual of your terminal device.
•It is essential that you observe these specications and the safety instructions regarding the
power supply of your devices.
•The power pack must not be charged and discharged at the same time!