Hama LED10S User manual

100
E
F
D
GB
NL
PL
CZ
RUS
Operating Instructions
Bedienungsanleitung
Mode d‘emploi
Instrucciones de uso
Руководство по эксплуатации
Gebruiksaanwijzing
Instrukcja obsługi
Návod kpoužití
Návod na použitie
Manual de instruçõe
Manual de utilizare
10000mAh
SK
P
RO
00
183362
Power Pack
“LED10S”

100
1
5
2 34
6

2
Controls and Displays
1. On/Off button
2. USB port
3. MicroUSB port
4. USB Type-C port
5. LED capacity indicator
6. 2-in-1cable
Thank you for choosing aHama product.
Take your time and read the following instructions and information completely.Please keep these
instructions in asafe place for futurereference. If you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to specichazards
and risks.
Note
This symbol is used to indicate additional information or important notes.
2. Package Contents
•Power pack with LED capacity display,10000 mAh
•2-in-1charging cable
•These operating instructions
3. Safety Notes
•The product is intended for private, non-commercial use only.
•Protect the product from dirt, moistureand overheating, and only use it in adry environment.
•Keep this product, as all electrical products, out of the reach of children!
•Donot drop the product and do not expose it to any major shocks.
•Donot operate the product outside the power limits given in the specications.
•Donot open the device or continue to operate it if it becomes damaged.
•Dispose of packaging material immediately according to locally applicable regulations.
•Since the battery is integrated and cannot be removed, you will need to dispose of the product as
awhole. Do this in compliance with the legal requirements.
•Donot modify the product in any way.Doing so voids the warranty.
4. Operation
4.1 Charging the Power Pack
•Begin charging the power pack by connecting the included 2-in-1charging cable to the power
pack’sMicro-USB (IN 5V/2A)input and to asuitable USB charger.Alternatively,you can also
charge the power pack using the USB Type-C input (IN 5V/3A). Please refer to the operating
instructions for the USB charger used.
•Charging begins and ends automatically.
•Charge the Power Pack fully beforeusing it for the rst time.
GOperating instruction

3
Note –Capacity
•The capacity is always shown when the Power Pack is charging.
•The LED capacity display gives the current charge level as apercentage. The capacity display
ashes during charging.
•Ifthe capacity display shows aconstant 100%, the power pack is fully charged.
•Press the button of the Power Pack to switch it on and to check its current capacity.
•Toswitch off the power pack, press and hold the button until the LED display goes out.
Warnung –Battery
•Only use suitable charging devices or USB connections for charging.
•Asarule, do not charge devices or USB connections that aredefective and do not try to repair
them yourself.
•Donot overcharge the product or allow the battery to completely discharge.
•Avoid storing, charging or using batteries in extreme temperatures.
•When stored over along period of time, batteries should be charged regularly (at least every
three months).
4.2 Charging terminal devices
•Connect the included 2-in-1charging cable to the power pack’sUSB connection (see 8. Technical
Data)and to the Micro-USB or USB Type-C connection of your terminal device (mobile phone,
smartphone, etc.).
•The included charging/connection cable may not be suitable for the USB port of your terminal
device. In this case, use the USB cable that was included with your terminal device.
•Charging begins automatically.The LED capacity display shows the remaining capacity of the
power pack when charging.
•The current battery status of your terminal device will appear on this device.
•Press the button on the power pack and hold it for approximately 2seconds to stop charging and
to switch the power pack off.The LED display goes out.
•The Power Pack will automatically switch off if it is not connected to aterminal device.
Warning –Connecting terminal devices
•Beforeconnecting aterminal device, check whether the power output of the charger can supply
sucient power for the device.
•Ensurethat the total power consumption of the connected terminal device does not exceed the
limit value (see point 8. Technical Data).
•Please refer to the instructions in the operating manual of your terminal device.
•Itisessential that you observe these specications and the safety instructions regarding the
power supply of your devices.
•The power pack must not be charged and discharged at the same time!
Note –Optimised charging
•Optimised charging means that the Power Pack recognises the connected terminal device and
supplies it with the optimal current to minimise charging time.
Warning
•Never connect the charging cable of the Power Pack to both the input and the output of the
Power Pack at the same time. This could damage the battery.
•Donot connect any terminal devices while the Power Pack is charging. This could damage the
Power Pack and the connected device.

4
5. Care and Maintenance
Only clean this product with aslightly damp, lint-free cloth and do not use aggressive cleaning
agents.
6. Warranty Disclaimer
Hama GmbH &CoKGassumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failuretoobserve the operating
instructions and/or safety notes.
7. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: [phone] (German/English)
Further support information can be found here:
www.hama.com
8. Technical Data
Micro-USB input 5V 2A
USB Type-C input 5V 3A
USB Type-C output 5V 3A
USB output 5V 2,4A
Output total 3A(max.)
Battery type 3.7V/Li-Po
Min. capacity 9553mAh/35.35Wh
Typ. capacity 10000mAh/37Wh
9. Recycling Information
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU and 2006/66/EU in the
national legal system, the following applies: Electric and electronic devices as well as
batteries must not be disposed of with household waste. Consumers areobliged by law to
return electrical and electronic devices as well as batteries at the end of their service lives
to the public collecting points set up for this purpose or point of sale. Details to this are
dened by the national law of the respective country.This symbol on the product, the instruction
manual or the package indicates that aproduct is subject to these regulations. By recycling, reusing
the materials or other forms of utilising old devices/Batteries, you aremaking an important
contribution to protecting our environment.