Hamilton Beach Scrubbing Bubbles User manual

Scrubbing Bubbles®
Automatic Shower Cleaner
Use and Care Manual
Save this manual for future reference.
If you have questions or comments,
please call 1-800-558-5252 or write Helen Johnson.
489025
prsncln ENv05.qxd 4/29/04 10:36 AM Page 1
MWA
Digitally signed by MWA
DN: cn=MWA, o=Hamilton 
Beach, ou=Engineering, c=US
Date: 2004.07.26 08:27:22 -04'00'
Signatur
e Not 
Verified

3
Parts and Features
1. Anti-Slip Ring
2. Hanger
3. Dispenser
4. Activation Button
5. Size AA Alkaline Batteries (4)
6. Bottles
Please call 1-800-558-5252
if you are missing any of
the parts listed above.
2
IMPORTANT SAFEGUARDS
READ AND SAVE
THESE INSTRUCTIONS
Safety First: Before showering, run water into the shower/tub area
to rinse the floor surface. Always stand on a non-slip surface when
in the shower or tub.
1. Read all instructions.
2. Make sure that dispenser is securely installed on the shower
pipe.
3. Use the appliance only for intended household use as described
in this manual.
4. Keep out of reach of children and pets.
5. Do not mix cleaner with other household cleaners, as hazardous
fumes may result.
6. Use alkaline batteries only. Note: Do not use lithium batteries.
7. Do not install batteries backwards, recharge, put in fire, or mix
with other battery types. They may explode or leak causing
injury.
8. Replace all batteries at the same time. Failure to do so could
cause the batteries to leak.
9. Do not use in a shower with brass fixtures, natural marble or
finished wood surfaces. Rinse surfaces well if the cleaner is
accidentally sprayed on these surfaces.
10. Cleaner may lighten natural fabrics, such as cotton. Avoid
contact with towels, washcloths, and other bath linens. Rinse
well if accidental contact occurs.
11. Do not submerge appliance in water.
12. Do not clean appliance in dishwasher.
First Aid: If eye contact occurs with cleaner, rinse with plenty of
water. If skin contact occurs, rinse with soap and water.
prsncln ENv05.qxd 4/29/04 10:36 AM Page 2

5
4
3. Push top of hanger flush against
the shower wall.
4. Snap anti-slip ring over shower
pipe in front of hanger.
To insert bottle:
Turn bottle upside down and gently
insert it into dispenser with label fac-
ing away from you. Firmly press bottle
down into dispenser. You should feel
a “pop.”
How to Use Your Automatic Shower Cleaner
For best results: Start with a clean tub/shower. The
Automatic Shower Cleaner is designed to combine with the
water on your shower walls and tub to prevent the build-up of
soap scum, hard water spots, and mold & mildew stains.
To Use:
1. Use immediately after last shower of the day while shower
is still wet.
2. To activate, press activation button. Dispenser will beep for
15 seconds before starting. You can stop dispense cycle
by pressing button again (you will hear two beeps.)
Installation Instructions
To insert batteries:
Remove battery cover completely from
back of dispenser and insert batteries
as illustrated. Replace battery cover.
NOTE: Use alkaline batteries only.
Do not use lithium batteries.
To assemble:
1. Align metal hanger with side
notches on back of dispenser.
Firmly push bottom of hanger into
notch. You will hear or feel a click.
2. Turn dispenser so that blue button
faces you. Place hook up over
shower pipe.
Top
View
Side
Notches
Side
Notches
Side
View
POP
prsncln ENv05.qxd 4/29/04 10:36 AM Page 4

7
6
How to Use Your Automatic Shower Cleaner
3. Close shower curtain or door in the 15 seconds before
dispensing starts.
4. Dispenser automatically shuts off and returns to stand-by
mode when dispensing is complete.
To change bottle:
1. When bottle is empty, hold
dispenser with one hand and
lift bottle out of dispenser,
turning it right side up.
2. Insert a fresh bottle by turning
upside down and gently
inserting it into dispenser with
label facing away from you.
Firmly press bottle down into
dispenser. You should feel a “pop.”
To change batteries:
1. Dispenser will go into stand-by mode and will not activate
when batteries need to be changed.
2. Remove dispenser from shower pipe. If bottle is not empty,
carefully remove it by inverting dispenser over sink and lift-
ing dispenser from bottle. Set bottle aside.
3. Remove battery cover completely from back of dispenser
and insert batteries as illustrated above under “Installation
Instructions.” Replace battery cover.
4. Invert dispenser back over bottle and press down snugly.
Reinstall onto shower pipe.
Cleaning dispenser: Wipe clean with a damp cloth.
Helpful Hints
• Cleaner is safe for use on most shower and tub surfaces,
including fiberglass, acrylic, and plastic. Do not use on brass,
natural marble or finished wood surfaces.
• Also safe for use on plastic and synthetic shower curtains.
May lighten natural fabrics such as cotton.
• Safe to spray on all personal care products like shampoo,
soap, and bath sponges.
• Will not harm pets.
• Cleaner will dry to a non-slippery surface between showers
to prevent the build-up of soap scum, hard water spots and
mold & mildew stains. As with all daily shower cleaners, run
shower before entering to rinse floor. Always stand on a non-
slip surface when in shower or tub.
• The dispenser sprays a pre-measured amount of daily shower
cleaner throughout your shower from the bottom of the dis-
penser to the shower floor. Because the cleaner is a clear liquid,
it will be difficult to see. Water will run off of treated surfaces in a
smooth sheet instead of beading up and leaving water spots.
• For best appearance, rinse shower/tub occasionally. Cleaner
works best on surfaces wetted during showering. If sprayed
onto dry surfaces cleaner may leave spots which can be
wiped off with a damp cloth.
• The formula works best to prevent the build-up of soap scum,
hard water spots and mold & mildew stains when starting with
a clean surface. However, it will provide a noticeable reduction
in existing mildew stains and soap scum deposits in as little
as two weeks when used on a daily basis.
• Only needs to be used once a day after the last shower to be
effective. Use it at any time, after the last shower in the
morning, afternoon, or evening.
prsncln ENv05.qxd 4/29/04 10:37 AM Page 6

9
LIMITED WARRANTY
This product is warranted to be free from defects in material and workmanship for
a period of one (1) year from the date of original purchase, except as noted below.
During this period, we will repair or replace, at our option, at no cost. THE FOREGO-
ING WARRANTY IS IN LIEU OF ANY OTHER WARRANTY, WHETHER EXPRESS OR
IMPLIED, WRITTEN OR ORAL INCLUDING ANY WARRANTY OF MERCHANTABILI-
TY OR FITNESS FOR A PARTICULAR PURPOSE. ANY LIABILITY IS EXPRESSLY
LIMITED TO AN AMOUNT EQUAL TO THE PURCHASE PRICE PAID, AND ALL
CLAIMS FOR SPECIAL, INCIDENTAL AND CONSEQUENTIAL DAMAGES ARE
HEREBY EXCLUDED. There is no warranty with respect to the following, which may
be supplied with this product: batteries. This warranty extends only to the original
consumer purchaser and does not cover a defect resulting from abuse, misuse,
neglect, use for commercial purposes, or any use not in conformity with the printed
directions. This warranty gives you specific legal rights, and you may also have other
legal rights that vary from state to state, or province to province. Some states or
provinces do not allow limitations on implied warranties or special, incidental or con-
sequential damages, so the foregoing limitations may not apply to you.
If you have a claim under this warranty, DO NOT RETURN THE APPLIANCE TO THE
STORE! Please call our CUSTOMER SERVICE NUMBER. For faster service please
have model, series, and type numbers ready for operator to assist you.
CUSTOMER SERVICE NUMBER
1-800-558-5252
KEEP THIS NUMBER FOR FUTURE REFERENCE!
8
Troubleshooting
Cleaner foams
PROBLEM THINGS TO CHECK
Appliance
hangs crooked
Appliance
interferes with
showerhead
hose
Appliance
beeps but does
not spray
• If device is new, press button again to
activate. May require up to 5 attempts
to activate on first use.
• Replace batteries.
• Replace batteries.
• Bottle is not inserted fully.
• Bottle is empty.
• Hanger is not snapped in place or fully
inserted in notches on dispenser.
• Hanger is not flush to wall; use anti-slip ring.
• Rotate joint of hose at end of pipe.
• Leave full bottle in device overnight then
activate again.
• Hanger is not flush to wall; use anti-slip ring.
Appliance
does not run
Bottle
collapses
Cleaner only
hits the bottom
of back wall
prsncln ENv05.qxd 4/29/04 10:37 AM Page 8

10
prsncln ENv05.qxd 4/29/04 10:37 AM Page 10