HAMPTON BAY Angelina User manual

LIMITED WARRANTY
The manufacturer warrants this lighting xture to be free from defects in materials and workmanship
for a period of ve (5) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the
manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident,
modications, alterations, neglect or mishandling. This warranty shall not apply to any product that is
found to have been improperly installed, set-up, or used in any way not in accordance with the instructions
supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident,
misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material
or workmanship. This warranty shall not apply to the nish on any portion of the product, such as surface
and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
specially disclaims any warranty, whether express or implied, of tness for a particular purpose, other
than the warranty contained herein. The manufacturer specically disclaims any liability and shall
not be liable for any consequential or incidental loss or damage, including but not limited to any labor
expense costs involved in the replacement or repair of said product.
Page 8 Page 1
INSTRUCTION MANUAL
HOME DEPOT SKU 598-318 | S/O: 426-484 (UPC 773546217477)
RUSTIC FINISH
INTERIOR 3-LIGHT SEMI-FLUSHMOUNT
ANGELINA
TROUBLESHOOTING:
Possible Cause Corrective Action
Bulb will not light
1. Bulb is burned out 1. Replace light bulb
2. Switch is off 2. Make sure switch is on
3. Faulty wire connection 3. Check wiring
Fuse blows or circuit
breaker trips when light
is turned on
Crossed wires or power
wire is grounding out Check wire connections
PRODUCT MAINTENANCE:
1. To clean the outside of the lamp, use a dry or slightly dampened clean cloth (use
clean water, never a solvent) to wipe the shade and surface of the lamp.
2. To clean the inside of the xture, rst disconnect power to the xture by turning
off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or
slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside
shade and interior surface of the xture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry
soft cloth to dust or wipe carefully.

Page 2
Thank you for purchasing this Hampton Bay interior decorative lighting. This product
has been manufactured with the highest standards of safety and quality.
FEATURES:
This contemporary but classic semi-ushmount with a rustic nish complements any
décor with its timeless look and style.
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service
Team at 1-877-527-0313 or visit www.homedepot.com. Please reference your
SKU 598-318 or (UPC 773546217477).
CAUTION:
1. Before starting installation of this xture or removal of a previous xture,
disconnect the power by turning off the circuit breaker or by removing the fuse at
the fuse box.
2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL
QUESTIONS.
3. If you have any non-electrical question about this xture, please contact our
Customer Service Team at 1-877-527-0313 or visit www.homedepot.com. Please
reference your SKU 598-318 or (UPC 773546217477).
4. Keep your receipt and these Instructions for Proof of Purchase.
INSTALLATION:
1. Junction Box
(not included)
14. Wire Nut (x3)
Ground Wire
Black Wire
White Wire
7. Ground Screw
2. Cross Bar
3. Outlet Box Screw (x2)
5. Canopy
4. Mounting Screw (x2)
Figure #1
WHITE OR RIBBED
FROM HOUSE
BLACK (OR RED) WIRE
FROM HOUSE
GROUND WIRE
FROM HOUSE
WHITE OR RIBBED
FROM FIXTURE
BLACK OR SMOOTH
FROM FIXTURE
GROUND WIRE
FROM FIXTURE
6. Decorative Cap (x2)
Page 7

ADDITIONAL PARTS FOR ASSEMBLY (included):
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
Safety goggles Wire Strippers Flathead
Screwdriver
A19 Bulb 60W max.
(not included)
Phillips
Screwdriver
Electrical Tape
Wire Cutters
Ladder
7. Ground Screw
4. Mounting
Screw (x2)
3. Outlet Box
Screw (x2)
6. Decorative
Cap (x2)
2. Cross Bar
Page 3
14. Wire Nut (x3)
INSTALLATION INSTRUCTIONS:
1. Turn off power at main fuse box.
2. Mount cross bar (2) onto junction box (1) with 2 outlet box screws (3) supplied.
3. Fasten open end of ground wire (bare copper or green wire), to ground wire or
ground screw of junction box (1) or ground screw on cross bar (2). (See g 1)
4. Connect black wire of power supply to black wire of the xture and the white wire
of the power supply to the white wire of the xture. ( See g 1)
NOTE: All wire connections should be made with wire nuts (14) or marrettes (included)
and pushed back into junction box (1).
5. Mount Canopy (5) of xture over mounting cross bar (2) and secure with 2 decorative
caps (6) supplied.
Page 6
ADDITIONAL PARTS FOR INSTALLATION (included):
10. Metal Washer 12. Diffuser 13. Decorative
Finial

ASSEMBLY INSTRUCTIONS:
1. Carefully unpack the xture; Layout all parts on a clean surface.
2. Install A19 Bulb 60W max.(not included).
3. Attach fabric shade (8) to the bottom of nipple (9).
4. Install metal washer (10), washer (11), diffuser (12) and over bottom nipple (9) and
secure them by fastening decorative nial (13) onto bottom nipple (9).
ASSEMBLY:
8. Fabric
Shade
9. Bottom
Nipple
10. Metal Washer
11.Washer
12.Diffuser
13.Decorative Finial
5. Canopy
6. Decorative Cap (x2) A19 Bulb 60W max.
(not included)
Socket
Page 4 Page 5