Hanover Victoria HBEDUPATHN-LN-FL User manual

Platform Bed
Assembly Instructions
Contains One Bed and Hardware
STEP 4
STEP 5
ASSEMBLY INSTRUCTIONS (CONTINUED)
A A
Insert the Center Rail (Part F) into the brackets on the
Headboard and Footboard. Using a screwdriver, secure the
center rail using two 16mm Screws (Part O).
Roll out the Wood Slat System (Part G) and secure it in place
using nine 32mm Screws (Part P). Use the pre-drilled holes
and a screwdriver.
F
F
O
G
P

A. Headboard Top (1 pc) B. Footboard (1 pc) C. Side Rail (2 pcs)
G. Wood Slat System (1 pc)
F. Center Rail (1 pc)
I. Support Bar (1 pc)
D. Side Wing (2 pcs) E. Footboard Leg (2 pcs)
H. Center Leg (3 pcs)
IMPORTANT NOTE:
Carefully remove all the parts from the box. Arrange on a at
surface and verify you have all of the following parts and hardware.
PARTS LIST
HARDWARE LIST
(Continued on back)
STEP 1
STEP 3
ASSEMBLY INSTRUCTIONS
STEP 2
TOOLS REQUIRED:
Phillips Screwdriver
AA
Assemble the Side Wings (Part D1 and D2) to the Headboard (Part A) using
four 40mm Bolts (Part J), four Spring Washers (Part K) and four Flat Washers
(Part L). Use the Small Hex Key (Part M) to secure the bolts. Be sure to use
Part D1 for the right side and Part D2 for the left side of the headboard.
Next secure the Support Bar (Part I) to the Side Wings (Part D) using two
40mm Bolts (Part J). Use the Small Hex Key (Part M) to secure the bolts.
Screw the Footboard Legs (Part E) into the Footboard (Part B). Screw
the Center Legs (Part H) into the Center Rail (Part F) using three
40mm Bolts (Part J). Secure the bolts using Small Hex Key (Part M).
Attach the siderails (Part C) to the Headboard (Part A) and the
Footboard (Part B) by hanging the siderails onto the pre-attached
bolts on the Headboard and Footboard. Tighten the bolts using
Large Hex Key (Part N).
L. Flat Washer
(4 pcs)
K. Spring Washer
(4 pcs)
O. 16mm Screw
(2 pcs)
P. 32mm Screw
(9 pcs)
N. Large Hex Key
(1 pc)
J. 40mm Bolt
(9 pcs)
M. Small Hex Key
(1 pc)
A
L
M
I
I
K
J
J
B
E
J
M
M
N
F
H
C