Hanover MONCHS2PC User manual


HanoverOutdoorFurniture




IMPORTANT
Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),
PLEASEDONOTRETURNTOTHERETAILER/STORE
fromwhereyoupurchasedtheproduct.
PleasecallourToll‐FreeCustomerServiceHotlineat:1‐800‐416‐3511
Between9:00AMand5:00PMEasternTime,MondaythroughFriday
Orvisitourwebsiteat:www.hanover‐products.com


Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty
Cardandreceiptforfutureuse.
For additionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor
furniture,pleasevisitourwebsiteat:www.hanover‐products.com.
6/1/2015(a)

Page 4
ASSEMBLY INSTRUCTIONS
1
2
From behind the chaise lounge back frame, insert a bolt with Ø8.5x1.5 mm washer through the hole in the lower
sling back frame. Add a Ø15x4 mm plastic washer before inserting into the fixed nut in side the sling seat frame
(see diagram). . Completely tightening at this point could cause the frame or
the sling seat to be uneven. Repeat for the opposite side.
Hand tighten 3-4 revolutions only
Using the hex wrench provided, tighten bolts. Tighten each bolt a few revolutions at time, alternating back
and forth between the two bolts until they are completely tightened. It is important to alternate between bolts
to ensure your frame and sling seat are even. . Over tightening could damage the threads
on the bolts or nuts.
Do not over tighten
D
E
C
A
B
FOOT CAP

Page 5
*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE
PARTS IDENTIFICATION LIST
5/16" X 42 MM BOLT HW0809 2
2
Ø15X4MMPLASTIC
WASHER HW0026
ADJUSTMENT BAR
FACTORY ASSEMBLY
BUMPER
FACTORY ASSEMBLY HW0078
SLING SEAT FRAME
1
1
SLING BACK FRAME
PARTS LIST DESCRIPTION ORDER PART # QTY
A
B
C
D
E
F
2
Ø8.5 X 1.5 MM
WASHER HW0005
SLING TUBE CAP-2
FACTORY ASSEMBLY FC0468
HEX BOLT DRIVER 1
HW0006
FC0030
FOOT CAP
FACTORY ASSEMBLY
SLING TUBE CAP 1-
FACTORY ASSEMBLY FC0005
ADL17002
AL1584
AL1585
AL1586