Hanover HAN-BARCART User manual

HanoverOutdoorFurniture
IMPORTANT
Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),
PLEASEDONOTRETURNTOTHERETAILER/STORE
fromwhereyoupurchasedtheproduct.
PleasecallourToll‐FreeCustomerServiceHotlineat:1‐800‐416‐3511
Between9:00AMand5:00PMEasternTime,MondaythroughFriday
Orvisitourwebsiteat:www.hanover‐products.com
Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty
Cardandreceiptforfutureuse.
For additionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor
furniture,pleasevisitourwebsiteat:www.hanover‐products.com.
6/1/2015(a)

ASSEMBLY INSTRUCTIONS
1
2
Attach the front frame to upper frame by ing two
the front frame upper frame
igureus 1/4"x20 mm bolts and washers as shown in . Guide
the bolts through holes in into the pre-drilled holes in the . Repeat
for the back frame.
F1
Hand tighten only.
Attach the base frame to the front frame by using two 1/4"x20 mm bolts and two 1/4"x32 mm bolts as shown
in . Add a washer to each bolt. Repeat for the back frame.F2 Hand tighten only.igure
A
D
FOOT CAP E
G
I
GI
H
I
G
I
G
I
B
H
I

ASSEMBLY INSTRUCTIONS
3
4
Insert the wheel into the threaded hole at the bottom of the serving cart rear leg as shown in . Use the hex
wrench to tighten the axle of the wheel. Repeat on the opposite side.
Fig. 3
After making any necessary adjustments to the alignment of the serving cart, use the hex bolt driver to tighten all
bolts. each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all bolt
joints, we recommend working in a cross corner (X) fashion. Repeat until all bolts are tight. .
Over tightening may strip bolts. Cover all bolts with covers provided.
Note:
Do not over tighten
D

*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE
PARTS IDENTIFICATION LIST
PARTS LIST DESCRIPTION ORDER PART # QTY
1
A
B
E
F
G
H
I
J
K
1
1
1
C
D
C
D
UPPER FRAME
BASE FRAME
WHEEL
BOX FRAME
1
2
FRONT FRAME
BACK FRAME
12
HW0004
Ø6.5 X 1.0 MM
WASHER
1/4" X 20 MM BOLT HW0036 8
1/4" X 32 MM BOLT HW0344 4
1
HEX BOLT DRIVER HW0006
HW0402 1
HEX WRENCH
FOOT CAP
FACTORY ASSEMBLY FC0653
AA0629
AA0630
AA0631
AA0632
AA0633
AA0634