Hans Grohe 04214 0 Series User manual

Hansgrohe
04214XX0
Installation Instructions

2
Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-
sional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
that you have all tools and supplies needed to complete the installation.
Know and follow all applicable local codes when installing this air gap.
•
•
•
Technical Information
Hole size in mounting surface 1-3/8"
Max. mounting surface depth 1-3/8"
Kitchen Air Gap
04214XX0

3
Installation
Remove the cover, collar, and sealing
ring from the air gap.
Rotate the nut clockwise to lower it on
the air gap.
Install a 5/8" dishwasher drain hose
on the 11/16" leg. Secure it with a
hose clamp Tighten the clamp.
Install a 7/8" garbage disposal hose
to the 15/16" leg. Secure it with a
hose clamp. Tighten the clamp.
Insert the air gap up through the hole in the mounting surface.
Install the sealing ring and collar.
Approximately 2 3/8" of the air gap should extend above the
mounting surface.
Tighten the nut.
Push the cover into place.

Hansgrohe, Inc. •1490 Bluegrass Lakes Parkway •Alpharetta, GA 30004
Tel. [phone] •Fax [phone]
www.hansgrohe-usa.com
US - Installation Instructions •Part No. 90494201 •Revised 2/2009
Cleaning Recommendation for Hansgrohe Products
Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of
the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain
criteria when cleaning.
Cleaning Materials for Faucets and Showers
Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the follow-
ing points when cleaning faucets and showers:
Only use cleaning materials which are explicitly intended for this type of application.
Never use cleaning materials which contain hydrochloric, formic, phosphoric, or acetic acid, as they cause
considerable damage.
Never mix one cleaning material with another.
Never use cleaning materials or appliances with an abrasive effect, such as unsuitable cleaning powders, sponge
pads, or micro fiber cloths.
Cleaning Instructions for Faucets and Showers
Please follow the cleaning material manufacturer’s instructions. In addition, pay attention to the following points:
Clean the faucets and showers as and when required
Use the amount of cleaning product and the amount of time recommended by the manufacturer. Do not leave the
cleaner on the fixture longer than necessary.
Regular cleaning can prevent calcification.
When using spray cleaners, spray first onto a soft cloth or sponge. Never spray directly onto the faucet as drop-
lets can enter openings and gaps and cause damage.
After cleaning, rinse thoroughly with clean water to remove any cleaner residue.
Important
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note: if the surface is already damaged, the effect of cleaning materials will cause further damage.
Components with damaged surfaces must be replaced or injury could result.
Damage caused by improper treatment is not covered under the warranty.
•
•
•
•
•
•
•
•
•