Hans Grohe Talis S 32020XX1 User manual

Installation Instructions / Warranty
Talis S
32020XX1

2
Talis S Lavatory Mixer
32020XX1
32020XX1
Technical Specification
Flow Rate 2.2 gpm
Max incoming water pressure 145 psi
Recommended incoming water pressure 14.5 - 72 psi
Max incoming hot water temperature 176oF*
Recommended incoming hot water temp. 120oF - 140oF*
Maximum mounting surface thickness 1 1/2”
Hole size 1 1/4”
*Prevent accidental scalding - know and follow all applicable local plumbing codes when setting the temperature on the water heater!
Installation Considerations
This faucet requires supply stops with 3/8” compression fittings (not included).
Please be sure that the faucet is in good condition, and that all parts are present before beginning
installation.
Flush the supply lines thoroughly before installing the faucet. Damage to the cartridge caused by
debris is not covered by the Hansgrohe USA Limited Lifetime Warranty.
The faucet includes a high temperature limit stop which should be re-set to protect children from
accidental scalding.
Installer - please leave this manual for the homeowner as it contains important information on the
faucet.

3
666
1
2
3
Installation
If the mounting surface is greater than 3/16”, leave
the spacer ring intact.
Place the mounting plate over the stud. Tighten the
collar so that it is snug against the bottom of the mount-
ing surface.
Install the supply hoses to the stops with the compres-
sion fittings, taking care not to twist the supply hoses.
Install the pop-up drain.
Re-set the high temperature limit stop.
Turn on the water and test all connections for leaks.
If the mounting surface is less than 3/16” thick, care-
fully trim the spacer ring so that it is even with the
bottom of the faucet.

4
User Instructions
Pivot the handle up to turn the water on, down to turn it off. Pivot the handle to the right for cooler
water, to the left for warmer water.
Install the Pop-up Drain:
Unscrew the flange from the tee. Place the tee and
sealing gasket on top of the sink. From below, install
the black mack gasket, plastic washer, and mounting
nut to the flange.
Thread the tee to the flange from beneath the sink.
The tee must be turned so that it faces the faucet.
When satisfied with the orientation, tighten the mount-
ing nut.
Sit the stopper assembly in the drain.
Install the horizontal rod so that the end goes through
the loop in the bottom of the stopper height adjuster.
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the horizon-
tal rod. Attach the swivel connector to the end of the
vertical rod. Position the vertical rod as desired, and
tighten it with a small, flat-bladed screwdriver.
Test the drain for function. If necessary, reposition the
swivel connector.
stopper assembly
height adjuster
flange
sealing gasket
mack gasket
plastic washer
mounting nut
pivot ball seal
pivot ball nut
horizontal rod
swivel connector
tee
tailpiece

5
1
2
Reset the high temperature limit stop:
Turn the water off at the stops. Push the handle to
the full up position (1). Loosen the handle screw 4
complete turns with a 4 mm allen wrench (2). Pull off
the handle (3) and the nut cover.
Turn the stem so that the handle screw faces forward.
3
Remove the handle screw (1). Pull off the high tem-
perature limit stop (2).
Reinstall the high temperature limit stop so that the pin
on the cartridge goes through the hole for the desired
high temperature.
The temperatures shown on the illustration assume
an incoming cold water temperature of 50oF, and an
incoming hot water temperature of 140oF.
Test the faucet. If the high temperature is still too hot,
reposition the high temperature limit stop.
Replace the nut cover (1). Replace the handle screw
and tighten it 4 complete turns.
Replace the handle (1). Finish tightening the handle
screw (2). Install the screw cover (3)

6
Replacement Parts
1 handle 32092000
1.1 screw cover 96338000
2 flange 96656000
3 nut 96690000
4 cartridge 92730000
5 handle screw 96059000
6 aerator 13085000
7 pop-up rod 96657000
8 mounting set 96016000
1.1 1
2
3
4
5
6
7
8

7
Cleaning Recommendation for Hansgrohe Products
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the
market with regard to design and functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment
is not covered under the Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
•To remove lime scale, use only products made specifically for that purpose. Always follow the
manufacturer’s instructions when using.
•Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause
considerable damage to finishes and to plastic components.
•Never mix cleaning materials.
•Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cleaning Procedures
•Clean your faucets and shower products as and when required. Regular cleaning will prevent scale
buildup and water spotting.
•Follow the label instructions. Do not allow any cleaner to remain on the product for longer than
necessary.
•When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the product.
•After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
•Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after use.
•If the surface is already damaged, harsh cleaning materials will cause further damage.
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to
Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or
Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship
as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product which proves defective
because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a
replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of
the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a
consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you own
the product and the home in which the product is installed. If you purchased the product for use primarily for any other purpose, including, without
limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Interaktiv and Retroaktiv products, and (ii) for 5 years,
with respect to AXOR, ShowerPower and Pharo products.

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004
Tel. [phone] • Fax [phone]
www.hansgrohe-USA.com
US - Installation Instructions • Part No. 90972021 • 01/2006
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident
or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner
contrary to the product instructions.
C. Labor or other expenses for the disconnection or return of the product for warranty service, or for installation or reinstallation of the product.
D. Accessories or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY SERVICE
Contact your Hansgrohe retailer, or write to Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Or, call Hansgrohe toll-free at [phone].
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492 Bluegrass Lakes
Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS
THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY
OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES,
ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you.
This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in
court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing,
always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions
at any time about the use, installation, or performance of your Hansgrohe product, or this warranty, please call or write to us at the toll-free
number and address printed above.