Happy Beds Corona Low End Bed User manual

Vendor: S000238
Page 2 of 6
Part Li t Hardware Li t (found in box 2)
Part De cription Box Qty Part De cription Qty
1 Headend Panel 1 1 A 30 mm Wooden Dowel 8
2 Footend Panel 1 1 B 40 mm Wooden Dowel 4
3 Left Headend Post 2 1 C 35 mm Screw 26
4 Right Headend Post 2 1 D 130 mm Bolt 10
5 Right Footend Post 2 1 E 130 mm Bolt 8
6 Left Footend Post 2 1 F Elliptical Nut 8
7 Side Rail 3 2 G llen Key 1
8 Slat 3 13 H Spacer 2
9 Headend Rail 3 1 J Stud 4
** You will need a mall mallet and a crewdriver
Step 1: Insert hardware part B using a small mallet (not provided).
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.

Vendor: S000238
Page 3 of 6
Step 2: Insert hardware part using a small mallet (not provided).
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.
Step 3: ttach the left headend post (3) and right headend post (4) to the headend panel (1) and headend
rail (9) using hardware parts D and G.
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.

Vendor: S000238
Page 4 of 6
Step 4: ttach the left footend post (6) and right footend post (5) to the footend panel (2) using hardware
parts D and G.
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.
Step 5: ttach the side rails (7) using hardware parts E, F and G.
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.

Vendor: S000238
Page 5 of 6
Step 6: Join the two assembled sections together using hardware parts E, F and G.
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.
Step 7: Secure the slats (8) using hardware parts H and C with a screwdriver (not provided). Make sure to
start from the ends and work towards the middle.
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.

Vendor: S000238
Step 8: Insert hardware part J using a small mallet (not provided).
DO NOT u e any power tool a thi may damage the frame and will invalidate any claim.
Note: When everything ha been a embled, tighten all bolt and attach the wooden button to the hole on
the bed po t

www.happybeds.co.uk
General Care & Maintenance
Please dispose of all packaging safely.
Wipe clean with a slightly damp cloth.
Avoid the use of all household cleaners and abrasives.
Periodically check all screw & fixings to ensure they are secure.
When moving your product, carefully lift into place. Never drag or push the pieces across the
floor as this will cause damage to the joints and could result in failure to the product that will
invalidate the warranty.
For more information on cleaning and product care visit:
https://www.happybeds.co.uk/help-and-advice
We’ve tried to make this product as easy to assemble as possible. In the unlikely event that
you have problems putting it together or have damaged or missing pieces, please contact
us by visiting:
https://www.happybeds.co.uk/customer-service
Notes