Harmony STUDY CARREL User manual

STUDY CARREL
1
www.harmonyspaces.ca
P A R T S A N D H A R D W A R E I N C L U D E D
Thank you for your order!
For questions or concerns regarding product or installation please contact us
at 519-451-4118 or via email at [e-mail]
Creating peaceful spaces in

STUDY CARREL
2
www.harmonyspaces.ca
S T E P 1
Place the end clips onto the rear edge of the
desk with the small slots facing upwards.
Lay the back panel at on the table with
notches on the long edge facing the
assembler.
S T E P 2
With the side panel arm facing upwards
slide the left side panel notches into the
back panel notches.
Note:
The left and right side panels are side
specic identiable by the double taper
(shape) dovetail notches whereas the
dovetails in the back panel have a single
taper. Due to the dierence in shape and
slight interference t only nominal force is
required to smoothly t the Study Carrel
together during assembly.
S T E P 3
Lift the back and side panel assembly
together into the vertical position and
reposition the back panel to the rear of the
desk while taking care to t and align the
left side panel arm under the desk.

STUDY CARREL
3
www.harmonyspaces.ca
S T E P 4
With the back panel at the rear of the desk
tilt the right side of the back panel upwards,
reposition and t the end clips into the
notches in the back panel while lowering
the back panel onto the table.
S T E P 5
Align and slide notches in the right side
panel into the notches of the back panel
while taking care to t the lower right panel
arm under the table.
S T E P 6
Recheck and verify the back, left and right
side panels, and end clips are securely t
together, the assembly sits at on the desk
and the study carrel is properly aligned with
the top of the desk.