Harrod HOC-055 User manual

HOC-055
2.44x0.61m Mini Hockey Goal & Net
INS055
Revision 0
07/12/2012
Harrod UK Limited©
Code:
Product:
Pack Contents:
1. 1 x Mini Hockey Frame (FEP129)
2. 1 x Mini Hockey Net Support & Fpack (FEP130)
(Contains FPK055)
3. 1 x Mini Hockey Net (HOC-059)
1x FPK055 Contains;
4. 2 x 100x10mm Carbine Clip (HKS007)
5. 2 x Internal ‘L’ Bracket (PLT126)
6. 2 x Ali Support Angle Bracket (PEQ925)
7. 10 x M10 x 25 Square Screw 19mm (BOL336)
8. 10 x M10 Nylock Nut (BOL202)
9. 8 x Flat Washer Form B ST/ST (BOL711)
10. 1 x EURO Net Hooks 80 Pack (FPK371)
11. 2 x Six Links Welded Chain (BOL827)
12. 2 x 10x450mm U-Peg (PEQ021)
View of Product
1
2
IMPORTANT PLEASE READ THE
ASSEMBLY INSTRUCTIONS
CAREFULLY BEFORE STARTING
TOASSEMBLEYOUR GOAL
Fig. 1
4
567
8
910
11
12

HOC-055
2.44 x 0.61m Mini Hockey Goal & Net
INS055
Code:
Product:
Assembly Instructions
1Using scissors (Do not use a knife), remove all the packaging
and Identify the parts using the Pack Contents and Fig 1
overleaf.
2Take 6 of BOL336 (6), slide 2 into the channel of one of the
frames (1), sliding them both into the longer section, which
will form the backbar. Slide another 2 of the bolts into smaller
section, as shown in Fig. 2, and repeat for the other side. These
bolts will be used to affix the two frames and the net supports.
3Slide the inner ‘L’ bracket into the frame channel as shown in
Fig. 2. Ensure the bracket sits all the way into the frame, as
shown in Fig.3. This will form the back of the frame.
Fig. 2
6
4
1
5With the first part of the frame placed flat on the floor, slide the front part of the frame onto the ‘L’ brackets so it fits
into the channel in the same way as the back of the frame, as shown below in Fig. 3.
Fig. 3
1
5
7
4Repeat step 2 with the other frame, slide the bolts into the
crossbar to ensure they don’t fall out of the frame during
assembly.

HOC-055
2.44 x 0.61m Mini Hockey Goal & Net
INS055
Code:
Product:
6Once the goal is assembled, secure the two frame components
with the white aluminium support angle bracket (5), M10
square screw (6), M10 nylock nut (7) and M10 washer (8) as
shown in Fig. 4.
Fig. 4
8Attach the net supports (2) using the remaining M10 square
screws (5), M10 nylock nut (7) and M10 washer (8) as shown
in Fig. 5.
1
8
9
6
7
Fig. 5
2
7
8
9
7Attach the chain, which will be used to anchor the product,
using the M10 screws and M10 washers, as shown below in
Fig. 5.
8
7
11
4
1