Harvia M3 User manual

Harvia M3 Wood Stove Installation (Chimney out the back wall) (Optional)
Reassemble the top chimney support bracket.
Serenity Barrel Sauna
Assembly Instructions
tel: [phone] | [e-mail]| web: www.leisurecraft.com
Manufactured by:
Install the cap on the top of the assembled chimney.
Install the bottom half of the exterior chimney shield.
Ensure that it is level.
Overlap the top half of the exterior chimney shield
and secure with provided screws.
Below the bench support on the back wall, mark the
vent hole position.
35

Harvia M3 Wood Stove Installation (Chimney out the back wall) (Optional)
Assemble together the remaining chimney pieces.
Serenity Barrel Sauna
Assembly Instructions
tel: [phone] | [e-mail]| web: www.leisurecraft.com
Manufactured by:
Attach the support strap around the 2 chimney pipes
and tighten up.
out the back of the sauna.
Attach a support strap around the connection and
tighten up.
34

Harvia M3 Wood Stove Installation (Chimney out the back wall) (Optional)
Bring in the rear wall heat shield and place it behind
the stove.
sauna and through the rear wall heat shield on the
inside of sauna and into the back of stove.
Serenity Barrel Sauna
Assembly Instructions
tel: [phone] | [e-mail]| web: www.leisurecraft.com
Manufactured by:
Ensure the rear wall heat shield is level and secure
with 6
Remove the nuts and bolts from the chimney support.
33

Harvia M3 Wood Stove Installation (Chimney out the back wall) (Optional)
(56mm)
from the floor up.
This will be the center of your hole for the chimney to
go out.
Cut out the circle with a jigsaw.
Serenity Barrel Sauna
Assembly Instructions
tel: [phone] | [e-mail]| web: www.leisurecraft.com
Manufactured by:
Install floor heat shield against back wall centered
between the benches.
Bring in stove and place it on the floor heat shield.
32

Harvia M3 Wood Stove Installation (Chimney out the back wall) (Optional)
Remove all protective film from stainless steel parts
and the plastic wrap from stove pipe pieces before
installation.
Fasten the stove handle onto the stove door With the
screws provided.
Serenity Barrel Sauna
Assembly Instructions
tel: [phone] | [e-mail]| web: www.leisurecraft.com
Manufactured by:
Remove the screw on the back of stove and remove
the back flap.
Measure the height to the middle of the opening on
31