Hasbro Playskool Clipo Guide 09949/09942 User manual

Thank you for choosing this
PLAYSKOOL product!
clipo™
creativity
table
09949/09942 Asst.
NOTE: Adult should remove and discard
rope handle and keep CLIPO ™ piece.
Includes: Table base, 2 storage buckets,
2 peg plates, 2 lids, motorized gear unit and
25 Clipo™ pieces (24 in box and 1 on handle).
Adult
assembly
required.
BATTERIES
ALKALINE
REQUIRED
x2
1.5V AA or
LR6 size
Phillips/cross head
screwdriver (not included)
needed to insert batteries.
NOT INCLUDED
ages &
stages®
months
18
OVER
TO INSTALL BATTERIES
Use a Phillips/cross head screwdriver
(not included) to loosen screw in
battery compartment door
(screw remains attached to cover).
Remove door. Insert 2 x 1.5V fresh
“AA” or LR6 size alkaline batteries.
Fit door into unit (tab into notch).
Tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and battery
manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to
insert them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline
batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it
away from other electrical equipment. Reset (switching off and back on again or
removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery.
Always remove from the product before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.

TO PLAY
The CLIPO™ CREATIVITY TABLE toy features (2) spinning turntables.
Center is stationary when assembled into table for stacking fun and display platforms!
1. Slide ON/OFF switch located on the
bottom of the motorized gear unit to
“ON” position.
· Press the button on top of the
motorized gear to run the motor.
This will start the center gear and turn
the two outside turntables.
The spinning continues for
approximately10 seconds, then stops.
Push the button again to re-start the
spinning action.
TO ASSEMBLE
1. Remove table from packaging.
2. To insure proper, one-time assembly: Place storage buckets on a flat surface
(such as the floor). Align base over storage buckets. Press down on base on one
side and carefully use body weight from above to apply pressure straight down
until you hear an audible snap. Repeat on other side.
3. Snap top two peg
plates onto the top,
in front and in back.
4. Set the two lids into
the recesses over
the storage buckets.
5. Drop motorized gear
into center, button side up,
after installing batteries.
Continued on next page
NOTE: Check to
insure tabs are fully
inserted in slots.
NOTE: To remove motorized
gear, use CLIPO™ piece and lift up.
Check to insure tabs
are in slots.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Questions? Call 1-800-PLAYSKL
7HRHS
7HRHS
BNLBNL
Product and colors may vary.
© 2008 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
09949 PN 6769550000
NOTE: When storing toy, turn the ON/OFF switch to OFF to prevent accidental
activation. If batteries begin to lose power, gears will turn at a slower rate and it will
be less powerful. For best results, replace batteries when this starts to happen.
3. 25 CLIPO™ pieces included to create a variety of designs.
Table surface acts as a platform to build CLIPO™ creations.
4. Works with all CLIPO™ products! Each sold separately.
Add them on for more CLIPO™ fun.
2. Each storage compartment’s lid incorporates an activity: one lid is a shape
sorter, the other one is a drop slot.