Hasbro FLASH ART Neon Paint Spinner 20251 User manual

Batteries included. Replace
with 4 x 1.5V “C” or LR14 size
alkaline batteries. Phillips/cross
head screwdriver (not included)
needed to replace batteries.
AGES 5+
20251
WARNING:
CHOKING HAZARD-Small parts.
Not for children under 3 years.
Note that paint may stain
some surfaces. Wash with
soap and warm water.
Thank you for choosing this
LITE BRITE product!
Thank you for choosing this
Includes paint spinner,
4 bottles of paint and
7 design cards

BASICS
1. Once spinning, you can press the button to control the
strobe patterns. Press the button to shuffle through all of
the strobe patterns.
2. Press the button once to shut off the music; press it a
second time to change the music.
1. Secure a design card onto the
spinner platform as shown.
Make sure all four corners
are in place.
GETTING CREATIVE
There are all kinds of amazing designs you can make with the
FLASH ART Neon Paint Spinner toy! Here are a few basics you’ll
need to follow before you begin to create:
2. Press the button
once to start the spinning
action! You’ll want to turn off
the lights in your room to get
the full glowing effect!
(first time playing: SEE NOTE)
3. Drip paint onto the spinning
design card. When finished,
press the button
once or twice to turn the paint
spinner off.
NOTE: To take the FLASH ART Neon Paint Spinner out of demo
mode, press either the or buttons while the spinner
is on (you will need to do this within the first 6 seconds the
spinner is on). Each time you replace the batteries, you will
need to repeat this step.
Once you have a feel for using the paints on your design
cards, you’ll want to experiment with different paint colors and
strobe patterns to create different effects. Here are a few play
suggestions:

3. You can drip two paints at once
to create a whole new effect.
Remember, you can use your
imagination to make all kinds of
cool designs!
OTHER IDEAS
Here are a few extra play features and
suggestions:
1. Put paint on your design card before
you place it on the spinner platform.
Try making a smiley face, a favorite
symbol or any design you wish!
2. Once the paint has dried on your
design card, you can stand the FLASH
ART Neon Paint Spinner upright and
put it on display in your room!
3. You can also frame or hang your dry
design cards.
4. Check out our FLASH ART Neon Paint
Spinner refill sets to create other cool designs.
Available at your local LITE BRITE retailer!
If your FLASH ART Neon Paint Spinner shuts off automatically
after 6 seconds, press either the or buttons while
the spinner is on. You will need to repeat this step each time
you replace the batteries.
CLEANING UP
Turn off the FLASH ART Neon Paint Spinner and wipe with a
damp paper towel to clean and prevent paint build-up.
TROUBLESHOOTING

© 2005 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S. Patent Pending
20251 P/N 6453540100
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
TO REPLACE BATTERIES
Use a Phillips/cross head screwdriver to
loosen screw in battery compartment door
(screw remains attached to door). Insert
4 fresh 1.5V “C” or LR14 size alkaline
batteries. Fit door back into place and
tighten screw.
CAUTION: TO AVOID BATTERY
LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert
them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away
from other electrical equipment. Reset (switching off and back on again or removing and
re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always
remove from the product before recharging. Recharge batteries under adult supervision.
DO NOT RECHARGE OTHER TYPES OF BATTERIES.