Hasbro GI Joe Moray 61238 User manual

(3) (8)
(5) (10) (12) (13)(4) (9)
(6) (7) (11) (11)
(2)
(1)
Some assembly required.
No tools needed.
Includes: unassembled
vehicle and figures.
WARNING:
CHOKING HAZARD-Small parts. Not for children under 3 years.
AGES 5+
61238
1. Position control bar with handle as shown.
Snap struts onto control bar. 2. Snap rear hydrofoil onto struts that are closest
to handle, as shown. Snap front hydrofoil onto
remaining struts.
3. Hold control bar handle. Lift front hydrofoil. Slide
control bar into hull, making sure control bar slides
under tabs. Fold hydrofoils into slots in hull.
4. With long mount in position shown, snap mount over
posts on front hydrofoil. Repeat with short mount
and rear hydrofoil. Slide handle back and forth to test
hydrofoils. NOTE: Put hydrofoils up before continuing.
5. Attach steering wheel and seats to interior. Place
assembled interior into vehicle as shown.
6. Insert tab on hull rear into hole in deck rear. Swing
deck down and snap tabs on hull into slots in deck.
GI JOE MORAY™ HYDROFOIL INSTRUCTIONS
Product and colors may vary. © 2005 Hasbro. All Rights Reserved. ® & TM denote U.S. Trademarks. P/N 6474770000
GI JOE MORAY™ HYDROFOIL
STRUTS
CONTROL BAR
HANDLE
REAR HYDROFOIL
FRONT
HYDROFOIL
HULL
FRONT
HYDROFOIL
CONTROL BAR
LONG
MOUNT SHORT
MOUNT
HANDLE
HANDLE
STEERING WHEEL
SEAT
SEAT
INTERIOR
TAB
HOLE
TABS
DECK
NOTE: Adult supervision may be required.
Remove all pieces from plastic frames.
If you have difficulty, use safety scissors.
1. HYDROFOILS. 2. TORPEDO. 3. RETRACTABLE MISSILE BOX. 4. DEFLECTOR SHIELD. 5. CANNONS. 6. PRESS ACTUATOR BUTTON TO REVEAL
MISSILE BOX.
7. SEARCHLIGHT. 8. PASSENGER’S SEAT HOLDS ONE FIGURE. 9. DRIVER’S SEAT HOLDS ONE FIGURE. 10. TURRET HOLDS ONE FIGURE. 11. M-30 WEAPONS. 12. STORAGE AREA. 13. REMOVABLE ENGINE COVER.

15
20
14
6
9
18
12
3
1
7
18
19
21
22
5
10
17
13
11
4
2
8
7. Insert “T” tabs on missile box bottom into holes in
missile box top. Slide “T” tabs toward rear of box.
Snap rear of missile box together.
8. Insert actuator button into hole in deck. Insert missile
box lever into hole in actuator button. Swing missile
box into place.
9. Position front of blast shield under top tabs on back of
missile box, and place one post on notch under deck.
Place other post of blast shield over deck opening and
snap into place. Press actuator button to lift missile
box. Insert missiles into missile box.
10. Snap hatch covers over hatch openings. Snap lens
into searchlight. Attach searchlight to vehicle.
11. Attach left windshield to left side of cabin as shown. Slide
windshield between ridge, and press into place. Repeat with
right windshield. Attach windshield gun to vehicle as shown.
12. Attach turret gun to turret. Snap turret into turret
hole. Attach side missiles to vehicle.
13. Attach left exhaust pipe to left side of engine as
shown. Snap bottom of exhaust pipe under engine
half. Repeat with right exhaust pipe. Attach tailpipe to
exhaust pipes.
14. Place front engine tab into slot in engine compartment,
and push rear tab into place. Attach depth charge caps
to depth charges. Slide depth charge tray into tray
compartments. Lift trays to insert depth charges.
15. Place storage covers over storage areas. Fit engine
cover over engine. Insert posts on M-30s into holes in
rear deck.
16. Attach torpedo halves. Attach assembled torpedo to
vehicle, and slide forward to lock in place. Repeat
with other torpedo. Snap cannons onto sides of
deck as shown.
17. Peel and apply labels as shown.
TOP
MISSILE BOX BOTTOM
“T”
TABS
ACTUATOR BUTTON
HOLE
HOLE
LEVER
BLAST SHIELD
MISSILES
POST
NOTCH
TAB
HATCH
COVER
HATCH
COVER
LENS
SEARCH
LIGHT
WINDSHIELD
WINDSHIELD
GUN
RIDGE
TURRET GUN TURRET
SIDE
MISSILES
LEFT EXHAUST PIPE
RIGHT EXHAUST PIPE
TAILPIPE ENGINE COMPARTMENT
DEPTH CHARGE
CAP
DEPTH
CHARGE TRAY
ENGINE COVER
STORAGE COVERS
M-30’s
TORPEDO HALVES
CANNON
CANNON
TORPEDO
M-30’s