Hasbro LITE BRITE 2215 User manual

INSTRUCTIONS & ART GUIDE
Use the bonus art pieces inside, along with the two included templates!
The letters tell you what color peg to insert through the paper and the into the holes
in the peg screen.
....................................
....................................
....................................
....................................
....................................
....................................
LITE BRITE is a trademark of Hasbro and is used with
permission. ©2016 Hasbro. All Rights Reserved.
Manufactured By
Basic Fun, a Div. of The Bridge Direct, Inc.
Boca Raton, FL 33431, USA
MADE IN CHINA
WARNING
BATTERY SAFETY INFORMATION
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn
injury or ruin your product. To avoid battery leakage:
- Do not use rechargeable batteries.
- Do not attempt to recharge non-rechargeable batteries.
- Do not mix alkaline, standard (carbon-zinc), and/or rechargeable (nickel-cadmium) batteries.
- Do not mix old and new batteries.
- Only use batteries or the same or equivalent type as recommended.
- Insert batteries with the correct polarity.
- Remove exhausted batteries from the product.
- Do not short-circuit the supply terminals.
- Dispose of batteries safety.
- Do not dispose of batteries in fire. Batteries may explode or leak.
- Sometimes a build-up of static electricity (from carpets, etc.) may cause the figure to stop working. If
this happens, re-install batteries to reset the toy.
- In an environment with radio frequency interference, the product may malfunction. If this happens,
re-install batteries to reset the toy.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try and correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio TV technician for help.
Please keep these instructions for future reference as they contain important information pertaining to
this item.
Item#
2215

TO INSTALL BATTERIES:
TO ATTACH/REMOVE STORAGE BOX:
Insert the storage box latches into the widest part of the housing key holes.
After inserting the latch into the widest part, slide the peg box down to
secure it in place.
2
1
2
1
Pull tab to open
lid & store your
pegs here!
Using Phillips/cross head screwdriver (not included), loosen screws in
battery compartment cover (screws stay attached to cover.) Remove
cover.
Insert 3 x 1.5V “AA” or R6 size batteries. Alkaline batteries recommended.
Replace cover and tighten screws.
TEMPLATE ART
GUIDE
Follow these templates to
create more fun designs! You can
also download these online at:
www.thebridgedirect.com