HOURS
HOURS
2
2
1
1
Remove cap from hopper and hold it with opening facing up.
Fill hopper with hydrated rounds.
Drain ALL water from hopper.
Holding blaster upside down, twist hopper onto blaster with
a 1/4 turn to lock it in place. Make sure hopper is securely
attached. Turn blaster right side up.
Open 1 packet and pour rounds into
container of clean tap water. It is
recommended to use at least 0.5
gallon/2 liters of water per 5,000 rounds.
If you want to hydrate only some of
the rounds in a packet and save some
rounds for later, use the same amount
of water. More water than recommended
will not impact hydration: It is not
possible to overhydrate the rounds
or grow them too large to function in
the blaster. Make sure rounds are fully
submerged in water.
Allow rounds
to remain in
container
for about 3-4
hours to be
fully hydrated.
2. HYDRATE ROUNDS1. CHARGING BATTERY 4. FIRE3. ATTACH HOPPER
Unlock trigger.
NOTE: Always turn selector to OFF
when not in use.
Full-auto:
Fires continuously while trigger is depressed.
Turn selector to desired mode:
Semi-auto:
Fires a round per trigger pull.
Selector Light
Steady
Selector Light
Off
Selector Light
Flashing
2
2
1
1
1
1
Using a USB-A to USB-C
charging cable, insert
the USB-C end into
battery charger port.
Attach the cable to
a USB-A wall charger
(not included).
It takes approximately
2 hours to fully charge
the battery.
• Light is steady when
charging.
• Light shuts off when
battery is fully charged.
• Flashing light: Charging
issue. Unplug and replug
charging cable, and try
charging again.
Store the battery outside of / separate from the blaster.
For peak performance, fully charge battery before each
battle. Recharge when rate of fire noticeably declines.
INSERT BATTERY
REMOVE BATTERY
CHARGE BATTERY
Includes rechargeable
7.4V 500mAh LiPo battery.
Replaceable.
Wear the included protective eyewear
when you or anyone else nearby is using
a Nerf Pro Gelfire blaster.
ROUND
STORAGE
Discard any
unused hydrated
rounds.
BLASTER STORAGE
Squeeze tabs and slide battery out of blaster.
IMPORTANT: RECHARGEABLE
BATTERY INFORMATION
Retain this information for future
reference. Batteries should be
replaced by an adult.
WARNING :
Risk of re, explosion, and burns. Do
not disassemble, crush, heat above
45 °C (113 °F), or incinerate. Dispose
of this battery according to your
local recycling or waste regulations
– never disassemble. Do not use the
item near a heat source such as a
re or heater.
CAUTION :
Risk of re and burns. Do not
open, crush, heat above 45˚C, or
incinerate. Follow manufacturer’s
instructions.
WARNING :
Use only with the device provided.
Chargers used with the product
are to be regularly examined for
damage to the cord, plug, enclosure
and other parts, and that, in the
event of such damage, the product
must not be used with this charger
until the damage has been repaired.
NOTE: The battery terminals are not
to be short-circuted.
3. Prior to storage, clean the blaster of
any Nerf Pro Gelfire round residue that
remains in the hopper feed or the barrel.
Use a long soft and clean item, such as
a cotton swab, to clear debris. Clean only
with a damp cloth or a soft, clean, dry item.
1. Store the battery
outside of / separate
from the blaster.
2. Make sure trigger lock
is in locked position
when storing the blaster.
USB-A to USB-C
CHARGING CABLE
